498239
13
Verklein
Vergroot
Pagina terug
1/20
Pagina verder
13
1-Channel-Mode: 1 Subwoofer / Mono
Speaker- & RCA-Connection
GTR1200.1
POWERPOWER
PROTECTPROTECT
BASS REMOTEBASS REMOTE
6V6V
40Hz40Hz
150Hz150Hz
0dB0dB 12dB12dB
BOOSTBOOST
0.2V0.2V
P ASSP ASS
I NPUTI NPUT
15Hz15Hz
55Hz55Hz
S ONICS ONIC
BASSBASS
LOWLOW
LEVELLEVEL
SUBSUB
CONTROL P ANELCONTROL P ANEL
OUTPUT OUTPUT
LL
RR
LINE INPUT LINE INPUT
LL
RR
FUS E
SPEAKER OUTPUT
GND REM 12V
POWER INPUT
Subwoofer
1 - 8 Ohm
Caution
Please avoid to connect speaker (-) to the ground or vehicle chassis.
Cable connection
• Connect INPUT of the amplifier to the head unit line output with good quality RCA cables.
By connecting the RCA jacks OUTPUT with a additional amplifier, a full range signal will be
provided to the amplifier. If your head unit is equiped with a separate Subwoofer Output it
is suggested to use this.
• Connect the subwoofer with the terminal block (SPEAKER OUTPUTS + / -) of the amplifier.
As option a additional Subwoofer can also be connected. The minimum total impedance
of both Subwoofer must be higher than 1 Ohm.
• Too low speaker loads result in too high heat dissipation and may cause the amplifier run into
protection.
• Please observe speaker channel and polarity as printed by the speaker terminal block.
Incorrect phasing of the speakers results in total loss of bass response.
LOW PASS - Control
Adjust a frequency between 40Hz - 150Hz, depending on the size and response of the Subwoofer.
SUBSONIC - Control
The SUBSONIC - Control adjusts the cut-off of the Subsonic-Frequency (lower Frequency cut-off).
Therewith a BANDPASS-Signal will be generated, where too low and not hearable frequencies will be eliminated.
Thereby a clean and powerful Bass-Signal will be generated. The adjustable level depends on the size and response of the
subwoofer and should be between 15Hz (no cut-off) and 55Hz (max. cut-off Level).
NOTE: If the SUBSONIC - Level is higher than the LOW PASS - Level, no Sound is hearable.
LEVEL INPUT - Control
• Turn the LEVEL INPUT - Control on the amplifier to "6V" position.
• Turn the head unit volume control to about 80-90% of its full setting.
• Turn the LEVEL INPUT - Control clockwise until you hear some distortion.
• Then turn back the LEVEL INPUT - Control slightly until you can hear clean sound.
BASS BOOST - Control
• The BASS BOOST - Control adjusts the bass level at 45 Hz from 0 up to 12dB. Please use the Bass-Boost carefully.
BASS REMOTE
• The BASS REMOTE allows to control the Bass-Level for example from the driver's seat.
Connect RCA cable
from head-unit with
RCA input (INPUT).
BASS REMOTE
OPTION:
As option an additional Subwoofer can be
connected with the non-occuppied Speaker
Terminals. Thereby check by any means the
changed impedance, the total impedance of both
subwoofers should not be lower than 1 ohm.
Maybe the Fuses of the Amplifier have to be
replaced with a higher Fuse Rating.
13

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Crunch GTR 2400.1 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Crunch GTR 2400.1 in de taal/talen: Duits, Engels als bijlage per email.

De handleiding is 0,45 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info