24
Please note:
Always ensure that the drawbar is properly secured! The securing pin must be inserted through both the holes – i.e. that of
the drawbar yoke as well as that of the drawbar itself – and the safety clip must be snapped over the end of the securing
pin. A drawbar which has not been secured properly can come loose during travel. This is extremely dangerous and can
cause accidents.
Loosen the safety clip on the securing
pin and withdraw the securing pin,
swivel the drawbar into the other
position,
To change the positions:
and snap the safety clip over the end
of the securing pin.
Final securing pin assembly
insert the securing pin through the
aligned holes in the drawbar yoke and
drawbar
2.3 Safety Flag
A flap for fixing the safety flag is provided on the left at the rear end.
3. Initial Operation
3.1 Fixing the Drawbar on the Bicycle
3.1.1 Fitting the Coupling Unit to the Bicycle
Always fit the drawbar and coupling on the left hand side in direction of travel!
The coupling unit should always be
attached in such a way that the square
points vertically downwards when seen
from the axle.
Only when the dropout or other features
of your bicycle make vertical fitting
impossible should the coupling unit be
attached horizontally, pointing
backwards.
Please note:
As the designs of dropouts can vary
considerably, there may be a few
isolated cases where it is impossible to
attach the coupling in any position.
If you are not sure how to attach the
coupling correctly to your bicycle
please ask your bicycle dealer.