Place the cuff direct to the skin, as clothing may cause a faint pulse, and result in a
measurement error.
2.Constriction of the upper arm, caused by rolled up shirtsleeves, may prevent
accurate readings.
3.Secure the arm cuff with Velcro Strip in such a way that it lies comfortably and is
not too tight. Lay the arm on the table with the hand palm upwards so that the arm
cuff is at the same height as the heart. Make sure that the tube is not kinked.
4.Measure your arm circumference for the cuff selection, refer to “Specifications”
How to take proper measurements
For the best accuracy in blood pressure measurement:
PATIENT position in NORMAL USE, including:
1) take a comfortable seat
2) keep your legs uncrossed.
3) place your feet flat on the floor.
4) keep your back and arm supported.
5) put the middle of the CUFF at the level of your heart.
Remain still and keep quiet during the measurement.
Relax as much as possible and do not talk during the measurement process.
Measure your blood pressure at about the same time every day.
Do not measure right after a physical exercise or a bath. Take a rest for twenty to thirty
minutes before taking the measurement.
The readings can be affected under the below conditions:
Within an hour after dinner, after having wine, coffee, tea, sports, bathing,
talking, being nervous, being in an unsteady mood, bending forward, moving, room
temperature dramatically changing during measuring, in moving vehicles, long
time continuous measuring.
HOW TO MEASURE BLOOD PRESSURE
1. Set up the arm cuff to your upper arm as previous described in the section
“ATTACHING THE ARM CUFF”
2. Press the “ON/OFF” button, all icons appear two seconds on the display, then it will
switch to measurement and will display “0” or the last measurement recorded.
3. Start the measurement, the cuff in the strap will automatically inflate. The mark () will
flash on LCD till the measurement is completed. The LCD display will show the
measurement results.
READ MEMORY
Press the “MEM” button, to read out the latest measurements. Press the “MEM” button
for the latest results (UP) or the “SET” button for the memory (DOWN)
Power Measurement closure or after the end of the state you can press the “MEM”
