470079
10
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
1
9
Coolermakesabad
smell.
Coolernotresponding
toremotecontroller.
Cooler makes noise.
Water overflows from the
tank.
Water colour yellowish at
initial use.
Coolerwillnotoperate
atall.
Damagedpowersupply
cord.
No cooling.
Cooler will not operate
initially.
CONDITION POSSIBLECAUSE REMEDY
Tankorcoolingpaddirty.
Waterqualityispoor.
Touchbuttonsafetylock
MoistureinPCB
RemoteControlbatteries
areold
RemoteControlreception
DamagedPCB
Lowwaterlevel.
MotororFanproblem.
Too much water in tank.
Colour bleeds from cooling
pad media.
Electricalfault.
Pump is not turned on.
Water tank is low or empty.
Pumpisnotworkingcorrectly.
Cooling pad blocked or dirty.
Cord is not plugged in.
Power outlet or supply faulty.
Incorrect voltage.
Drain the tank and fill the cooler with clean water. If it still
smells, clean the tank and replace the cooling pad.
Add a little vanilla essence orperfume to the water.
Unlock safety feature, press POWER and COOL buttons
on the control panel at the same time until power indicator
light comes back on.
Try using the remote control to see if the unit responds. If
the unit responds briefly, the likely cause is moisture in
the PCB. Turn the unit off, unplug the power and call
customer service.
Check batteries in the remote controllerand replace.
Remote reception distance will be significantly reduced
under direct sunlight.
If none of the above solutions work, the PCB/ Touch
screen assembly is damaged. Call customerservice.
Wheneverthewaterlevelisbelowminimum,theCOOL
displaywillcontinuouslyflashandawarningsoundwill
beepfor10seconds.
Refillthewatertankwithfreshwaterandturnonthe
COOL function.
Turnoffandunplugtheunit.Callcustomerservice.
Drain some water out of thetank.
This is normal.After several uses, the water colour will be
clean.
Electrical parts must only be repaired and replaced by
Authorised ServiceAgents.
If the power supply cord of this appliance is damaged it
must be replaced. Electrical parts must only be repaired
and replaced byAuthorised ServiceAgents.
Turn cool mode on by pressing theCOOL button.
Make sure the COOL symbol is not flashing indicating low
water. Fill with water again until water level indicates the
tank is full.
Call customer service
Drain the tank and fill the cooler with clean water. This will
help dissolve and flush out the dirt. The cooling pad
should now be wet.
Ensure cord is plugged in andswitched on at power outlet.
Check the power outlet. Check the power supply
Check that the power supply is the same as specified on
the rating label.
TROUBLESHOOTING
10

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Convair SI 5000 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Convair SI 5000 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,24 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info