743663
62
Verklein
Vergroot
Pagina terug
1/63
Pagina verder
TDMA CONTROL 601/701:
62
Published 07/2007
7 Problems and Solutions
Problem:
Cause:
Remedy:
Indicator
.. flashing and sensor fault indi-
cated.
Sensor is interrupted or short circuited.
Check sensor fitting and replace sensor if
necessary.
Regulator is not set correctly.
Check whether a function is activated even
though there is no sensor connected. Deac-
tivate the function.
Solar pump
. ... doesn’t run.
The regulator doesn’t switch the solar
pump on, even though there is sufficient
solar energy to store.
This may not be a fault! The regulator has
paused the solar pump operation as pro-
grammed. See the Technical Documentati-
on under „Solar Pump Operation“.
The solar pump is defective or is incor-
rectly installed.
Test the connection and replace the pump
if necessary.
... switches off because the tempera-
ture in the collector is too high, al-
though the upper thermal store tem-
perature has not reached 90 °C.
The flow volume has been incorrectly
set resulting in too high a difference
between the collector inflow and out-
flow temperatures.
Check the flow volume reading on the Ta-
cosetter or CONTROL601/ 701 (only if
using flow volume measuring to measure
yield). The flow volume must be set at 25
litres per hour and square meter.
Incorrect collector sensor securing. The
absorber temperature is incorrectly
measured.
The sensor should be fitted to the furthest
possible absorber plate, close to the ab-
sorber pipework, so that it receives the
same insolation levels. See also the instal-
lation instructions.
No hotwater
The regulator is incorrectly set.
Check the hot water temperature and time
programme and reset as necesssary.
Temperature sensor or thermal store
loading pump is defective.
Replace sensor or pump.
Heating system:
... Room temperature is too high
when the external temperature is
low or to low when the external
temperature is high.
Heating graph gradient or curvature is
incorrectly set.
Check the regulator settings and reset as
necessary.
...Rooms are cold even though the
boiler is running.
Heating pump is not functioning.
Check the connection and replace the
pump if necessary.
Regulator is incorrectly set.
See the Technical Documentation under
„Operating the Heating and Boiler“ Func-
tions.
If hot water demand has been priori-
tized, the thermal store is loaded as the
priority function and the heating circuit
mixer is switched off.
Deactivate the priority setting if not re-
quired.
Individual menu points or function
options do not show in the display.
The relevant function has not been cho-
sen.
If necessary, activate the function in the
System Variations menu.
62

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Consolar Control 701 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Consolar Control 701 in de taal/talen: Engels als bijlage per email.

De handleiding is 5,12 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info