756996
105
Verklein
Vergroot
Pagina terug
1/176
Pagina verder
ComNav Admiral P3 Installation & Operation Basic Operations
Document PN 29010075 V3.1 - 103 -
Power Steer Menu
The Power Steer menu contains the “mechanical” steering parameters (which are common to
all modes). To access the Power Steer menu, double-press the P.STR button.
Figure 75 – Power Steer Menu
Stdby/P.Str Limits (Power Steer Rudder Limits)
When you set up the Admiral P3 system (see Setup Procedures on page 80), you will move
the rudder from hard over port to hard over starboard so that the autopilot can measure these
positions. These hard over positions are known as the “physical limits”, beyond which the
rudder simply cannot be turned. However, you can artificially limit the rudder travel through
the autopilot software.
Set the Power Steer 4 Limits to the number of degrees port and starboard that you would like
to limit the rudder movement to. These rudder limits will be in effect whenever the autopilot is
in POWER STEER mode. The minimum setting is 5°; the maximum is the same as the
physical limits measured in Dockside Setup. Setting the limits to “Off” means that the full
range – up to the physical limits – will be allowed. The limits selected will be shown on the
bottom bar of the Rudder Angle Indicator display during normal operation, in red and green.
Auto/Nav Limits
The Auto/Nav Limits are essentially the same as the Power Steer Limits detailed above, but
they are in effect only when the autopilot is in AUTO or NAV modes.
RAI Offset
The RAI (Rudder Angle Indicator) display at the bottom of the autopilot display may require a
slight offset adjustment in order to read zero degrees when the vessel is moving in a straight
line. This is a fairly common scenario and may be due to vessel loading or design, rudder
design or function, or the installation of the Rudder Feedback Unit. For example, if the vessel
is traveling in a straight line, but the RAI reads 2° to starboard, adjust the RAI Offset to port
so that the RAI display reads zero.
4 SPU firmware versions before 3.05 allowed the Rudder to be moved in Standby mode, with a Jog Lever, but this feature
was disabled in that version & onwards, for safety reasons. The parameter name was not changed, however.
105

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw ComNav Admiral P3 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van ComNav Admiral P3 in de taal/talen: Engels als bijlage per email.

De handleiding is 4,57 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info