756996
90
Verklein
Vergroot
Pagina terug
1/176
Pagina verder
ComNav Admiral P3 Installation & Operation Getting Started
Document PN 29010075 V3.1 - 88 -
Compass Setup – On the Water
The final part of compass setup is normally performed after all other installation and setup
procedures for the Admiral P3 system are completed, so that all net electrical and magnetic
effects of the installation on the compass(es) are taken into account.
Note: some of the steps performed here require that you be familiar with
the STANDBY mode & menu of the Admiral P3 system (see page 99).
This part of compass setup requires taking your vessel away from the dock, and out onto a
body of open water (the sea, a lake, a river, etc.), and should be done in relatively calm
conditions.
It is important that there be sufficient sea room to put the boat through a series of fairly slow
& wide circle turns, and to run the boat for several minutes in a straight line at various
headings, without encountering obstacles, other marine traffic, etc. You should also avoid
areas around bridges, underwater power lines, and pipelines, as these can affect your
compasses.
CAUTION! Be sure to keep a proper lookout for other vessels, and any hazards,
while doing any of the circle turns & other manoeuvres described below.
Compass Compensation
The specific procedure you will follow depends on the type(s) of compasses you have
installed. Each is described below.
Note: during all these procedures, the INVALID HEADING alarm may
occur. You can cancel any such alarm, or leave it active.
Magnetic Compass Sensor
If you have a magnetic compass with a ComNav Magnetic Sensor attached, the compass
must be properly compensated for deviation. It is recommended that a professional compass
adjuster do this.
Once the compensation is completed, follow the instructions below to synchronize the
Magnetic Sensor with the Earth’s Magnetic North direction:
1) Power up the autopilot. Double-press the STANDBY/ON/OFF button to bring up the
Standby menu. Select “Compass Source”, and make sure it is set to “Analog”.
2) Shut off the autopilot, then power it up in the Dockside Setup menu.
3) Ensure that the “An. Compass Type” is set to “Mag”.
4) Select Compass Setup & press the Fn button.
5) After the Admiral P3 has auto-detected the compass, it will ask you if you want to
SET NORTH NOW? (see Figure 68). Press the STARBOARD ARROW button.
Manually steer the vessel so that it is pointing to Magnetic North. Hold it on that
heading and push the Fn button. The Admiral P3 will store the current heading and
reference it as 000° Magnetic. When this is done, the Admiral P3 will automatically
return to the Dockside Setup menu.
6) Highlight “Exit” and then press the Fn button. After a brief pause the autopilot will
restart and automatically go into STANDBY mode.
7) Now do the Compass Calibration procedure, on page 92.
90

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw ComNav Admiral P3 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van ComNav Admiral P3 in de taal/talen: Engels als bijlage per email.

De handleiding is 4,57 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info