756996
85
Verklein
Vergroot
Pagina terug
1/176
Pagina verder
ComNav Admiral P3 Installation & Operation Getting Started
Document PN 29010075 V3.1 - 83 -
Bleeding a Hydraulic Steering System
The Admiral P3 will pause the Drive Setup process at this point, and prompt you to bleed
your hydraulic steering system.
Note: If you do not have a hydraulic system, just press the Fn button on
the Control Head, to carry on with the Drive Setup, and go to Drive Setup
step 6) on page 85.
Whether you have installed an entirely new hydraulic system, or added a hydraulic pump
controlled by the Admiral P3 onto an existing mechanical or hydraulic system, the ENTIRE
hydraulic system must be bled of any air trapped in the hydraulic oil, otherwise the steering
system will not perform properly.
Bleeding a typical system using a P3-controlled Reversing Motor hydraulic pump added onto
an existing manual steering system is done in the following steps; other systems will be
similar.
Caution: SAFETY GLASSES SHOULD BE WORN DURING THE STEPS BELOW.
1. First, bleed the manual portion of the steering system (Helm pump, lines & steering
cylinder), according to the manufacturer's instructions. When you have completed
bleeding the manual system, leave the equipment that you used (funnels, catch cans,
etc.) attached to the hydraulic system.
2. Check that the highest hydraulic reservoir in the system is completely filled; top it up,
if necessary. If possible, use a bottle of your system’s hydraulic oil & a piece of
plastic tubing to add extra capacity to the highest reservoir (see the figure below). If
you have a helper, have them watch the oil level in the highest reservoir, and refill it
when necessary.
Figure 63 – Adding Fluid Capacity
3. Turn the steering wheel hard against the stop, to press as much oil as possible into
the system. The hydraulic cylinder rod should now be fully extended in one direction.
4. To bleed the Reversing Pump, you will need to extend – using the autopilot – the
cylinder rod in the other direction, and back again, repeatedly, until all air is removed.
Open one bleed screw (or nipple) on the hydraulic cylinder and close the other.
Normally, you close the bleed screw closest to the end of the rod that is now
retracted, and open the bleed screw closest to the rod end now extended (see
Figure 64). Be sure to position the catch can under the open bleed screw, first.
85

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw ComNav Admiral P3 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van ComNav Admiral P3 in de taal/talen: Engels als bijlage per email.

De handleiding is 4,57 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info