551785
27
Verklein
Vergroot
Pagina terug
1/50
Pagina verder
27
WARNING: Risk of injury!
1. Disconnect the mains plug from the wall socket.
2. Only open the appliance after the pressure has been
released. Press the steam button to do so.
3. If the appliance is still warm, wait approx. 5 minutes until
removing the lid.
4. Press down the lid and turn it anticlockwise to remove.
5. Pour any remaining water from the boiler in order to avoid
overlling.
6. Use the funnel to ll the boiler with a maximum of 600 ml of
water.
7. Attach the lid by turning it clockwise and applying pressure
at the same time.
Installation of accessories
You have the option of attaching the individual nozzles
directly onto the handle. Insert the accessory onto the
handle until the button (7) clicks into place. To release the
accessory, press the button (7) on the handle.
The extension pipes enable you to work in large or high ar-
eas. Insert them into each other until the button on the pipe
clicks into place. Attach the pipe to the handle as described
above. To separate the pipes, press the button on the pipe
again.
If you want to clean sensitive oor surfaces, also attach the
eece cloth to the oor brush.
For joins, xtures and ttings or hard to reach areas, screw
the round brush onto the jet nozzle attachment.
Electrical Connection
Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device.
You can nd this information on the nameplate.
Connect the device to a duly installed protective contact
socket.
Using the Device
CAUTION:
Before you begin cleaning you should test the materials to
be cleaned as to their suitability for cleaning with steam. Do
not hold the steam nozzle for too long and too close in one
position.
1. To switch on the appliance, set the on/off switch to position I.
2. Pressure starts building up in the boiler after approx.
6 minutes.
3. Press the steam button to generate steam.
NOTE:
After a long period of non-use, it is normal that a small
amount of condensation, which has formed in the pipe,
will leak out at rst.
Using the appliance with the maximum water amount
and in continuous operation will allow for steam genera-
tion of up to 15 minutes.
Filling the Water Tank during Operation
No steam will be discharged if the water tank is empty. The
water has to be lled up as follows:
1. To switch off the appliance, set the on/off switch to position
O.
2. Remove the mains plug from the socket!
3. Fill fresh water into the tank as described in the chapter “Fill
in Water” (steps 1-6).
4. Connect the plug to the socket again and switch the appli-
ance on to continue operation.
When you have nished using the device
1. To switch off the appliance, set the on/off switch to position
O.
2. Remove the mains plug from the socket!
3. Let the unit cool down completely.
4. Empty the water tank.
Cleaning
WARNING:
Always remove the mains plug before cleaning the device.
Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or re.
27

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Clatronic DR 3536 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Clatronic DR 3536 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Spaans, Pools als bijlage per email.

De handleiding is 5,43 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info