538691
37
Verklein
Vergroot
Pagina terug
1/41
Pagina verder
37
Introduction
How to install the
unit on your bicycle
Setting up the
computer
How to use the
computer
Setup of your PC
Uploading the
measurement data
Changing the
computer
configuration
Others
Trouble Check Items Remedy
MEM FULL flashes. Does the maximum re-
cording time or the num-
ber of trips exceed the
upper limit?
* For details, see “Record
interval and capacity
limit” (page 23)
Connect the computer to your PC
to upload the trip data (page 20).
All the trip data transferred to your
PC will be deleted from the com-
puter, and new data will be able to
be recorded.
Does the maximum time
for one trip exceed the up-
per limit?
* For details, see “Record
interval and capacity
limit” (page 23)
Perform the resetting operation
(page 16) to stop the current trip.
Then, you can record as another
trip.
The backlight does not
light up even at the
preset hour.
Are the start time and end
time set to the same hour?
The backlight does not light up
when the start time and end time
are set to the same hour.
For information on how to set the
start/end time, see “Changing the
computer configuration” (page 27).
Is the start time of the
night-time set correctly?
For information on how to set the
start time, see “Changing the com-
puter configuration” (page 27).
The backlight lights up
during the daytime.
Troubles related to the ANT+ sensor
Refer to the following information when the optional or commercial ANT+ sensor is used.
* Pairing with the computer is required in order to use the ANT+ sensor. For details, see
“Pairing the sensor” (page 32).
* When a commercial ANT+ sensor is used, also refer to the instruction manual supplied
with your sensor.
Trouble Check Items Remedy
The heart rate can-
not be measured (
H
does not flash).
Did you perform pairing
with the heart rate sensor?
Perform pairing (page 32).
Is the electrode pad de-
tached from your body?
Wear the electrode pad appropri-
ately so that it is in close contact
with the body.
Is your skin dry? Moisten the electrode pad a little.
Is the electrode pad overly
worn and damaged after
long use?
Replace with a new one.
Is the battery for the heart
rate sensor used up?
Replace with new batteries.
The heart rate mea-
surement is not con-
stant (measurement is
performd at times, or
reset to 0).
Is the heart rate sensor
attached correctly?
Attach the heart rate sensor in the
correct position by referring to the
relevant instruction manual.
The power cannot be
measured (
P does
not flash).
Did you perform pairing
with the power sensor
used?
Perform pairing (page 32).
Is the condition for
mounting the power sen-
sor cleared?
Mount the power sensor correctly
by referring to the relevant instruc-
tion manual.
Is the battery for the
power sensor used up?
Replace with new batteries.
37

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Cateye CC-GL50 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Cateye CC-GL50 in de taal/talen: Engels als bijlage per email.

De handleiding is 3,24 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Cateye CC-GL50

Cateye CC-GL50 Gebruiksaanwijzing - Nederlands - 41 pagina's

Cateye CC-GL50 Gebruiksaanwijzing - Deutsch - 41 pagina's

Cateye CC-GL50 Gebruiksaanwijzing - Français - 41 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info