633318
7
Verklein
Vergroot
Pagina terug
1/10
Pagina verder
Operation Guide 5444
E-69
x The above operation turns on illumination regardless of the current auto light switch
setting.
x Illumination is disabled during time calibration signal reception.
To change the illumination duration
1. In the Timekeeping Mode, hold down A for about two seconds until ADJ
appears in the right digital dial.
When you release A, the city code and city name will scroll across the right
digital dial. This is the setting mode.
x Whenever you enter a setting mode, the analog hands will automatically move to
positions that allow easier viewing of the digital dials.
2. Use C to cycle through the settings in the right digital dial until the current
illumination duration (LT1 or LT3) is shown.
x See the sequence in step 2 of the procedure under “To change the current time
and date settings manually” (page E-48) for information about how to scroll through
setting mode.
E-68
Illumination
The face of the watch is illuminated for easy reading in
the dark.
The watch’s auto light switch turns on illumination
automatically when you angle the watch towards your
face.
x The auto light switch must be turned on (page E-72) for it
to operate.
To turn on illumination manually
Press B in any mode to illuminate the face of the watch.
x You can use the procedure below to select either
1.5seconds or three seconds as the illumination
duration. When you press B, the face will remain
illuminated for about 1.5 seconds or three seconds,
depending on the current illumination duration setting.
E-67
Alarm Countdown
When the current time reaches one hour before an alarm
time setting, the alarm on/off indicator (in the lower digital
dial) will fl ash and a countdown of the fi nal 60 minutes
will be displayed in the right digital dial while the watch is
in the Timekeeping Mode.
Note
x Pressing A while an alarm countdown is in progress
will display the day of the week in the right digital dial for
about two seconds. After that, the dial will return to the
countdown.
x When you enter the Timekeeping Mode from another mode while an alarm
countdown is in progress, the day of the week will appear in the right digital dial for
two seconds. After that, the countdown will appear.
x If an alarm countdown for another alarm starts while a previous alarm countdown is
already in progress, it will be displayed after the ongoing countdown reaches zero
and its alarm sounds.
Alarm ON/OFF indicator
Alarm Countdown
E-66
To turn an alarm and the Hourly Time Signal on and off
1. In the Alarm Mode, use D to scroll through the alarm
indicators (AL1 to AL5, SIG) in the right digital dial until
the one you want is displayed.
2. When the alarm or the Hourly Time Signal you want is
selected, press A to toggle it between on and off.
x The alarm on indicator (when any alarm is on) and the
Hourly Time Signal on indicator (when the Hourly Time
Signal is on) are displayed in all modes.
To stop the alarm
Press any button.
Hourly Time Signal
on indicator
E-65
4. While a setting is fl ashing, use D (+) and B (–) to change it.
x When setting the alarm time using the 12-hour format, take care to set the time
correctly as a.m. (no indicator) or p.m. (PM indicator).
5. Press A to exit the setting mode.
x Exiting a setting mode will normally cause the hands to return to regular
timekeeping automatically. However, if you manually move the hands (page
E-79) and then enter a setting mode, they will not return to regular timekeeping
automatically when you exit the setting mode. In this case, you will need to
return the hands to their normal positions manually (page E-80).
To test the alarm
In the Alarm Mode, hold down D to sound the alarm.
E-64
To set an alarm time
1. In the Alarm Mode, use D to scroll through the alarm
indicators (AL1 to AL5, SIG) in the right digital dial until
the one whose time you want to set is displayed.
AL1 AL3 AL5AL2 AL4 SIG
DDDDD
D
2. Hold down A for about two seconds until the alarm time starts to fl ash. This is
the setting mode.
x Whenever you enter the setting mode, the analog hands will automatically move
to positions that allow easier viewing of the digital dials.
3. Press C to move the fl
ashing between the hour and minute settings.
Alarm ON/OFF indicator
E-63
Using the Alarm
You can set fi ve independent daily alarms. When a daily
alarm is turned on, an alarm tone will sound for about
10 seconds each day when the time in the Timekeeping
Mode reaches the preset alarm time. This is true even if
the watch is not in the Timekeeping Mode.
You can also turn on an Hourly Time Signal, which will
cause the watch to beep twice every hour on the hour.
To enter the Alarm Mode
Use C to select the Alarm Mode as shown on page E-39.
x The right digital dial will show ALM for about one
second and then the indictor for the currently selected
alarm (AL1 through AL5, or SIG) will appear.
x When you enter the Alarm Mode, the data you were
viewing when you last exited the mode appears fi
rst.
Alarm number
Alarm time (Hour : Minutes)
E-62
To perform a countdown timer operation
D
D D D A
Start Stop Resume (Stop) Reset
x Before starting a countdown timer operation, check to make sure that a
countdown operation is not in progress (indicated by the seconds counting down).
If it is, press D to stop it and then A to reset to the countdown start time.
x An alarm sounds for 10 seconds when the end of the countdown is reached. This
alarm will sound in all modes. The countdown time is reset to its starting value
automatically when the alarm sounds.
To stop the alarm
Press any button.
E-61
2. Hold down A until the minute setting of the current countdown start time starts
to fl ash. This is the setting mode.
x Whenever you enter a setting mode, the analog hands will automatically move to
positions that allow easier viewing of the digital dials.
3. Press C to move the fl
ashing between the minute and second settings.
4. Use D (+) and B (–) to change the fl ashing item.
x To set the starting value of the countdown time to 100 minutes, set 00'00".
5. Press A to exit the setting mode.
x Exiting a setting mode will normally cause the hands to return to regular
timekeeping automatically. However, if you manually move the hands (page
E-79) and then enter a setting mode, they will not return to regular timekeeping
automatically when you exit the setting mode. In this case, you will need to
return the hands to their normal positions manually (page E-80).
E-60
Using the Countdown Timer
The countdown timer can be set within a range of one minute to 100 minutes. An
alarm sounds when the countdown reaches zero.
To enter the Countdown Timer Mode
Use C to select the Countdown Timer Mode (TMR) as
shown on page E-39.
To specify the countdown start time
1. Enter the Countdown Timer Mode.
x If a countdown is in progress (indicated by the
seconds counting down in the left digital dial), press
D to stop it and then press A to reset to the current
countdown start time.
x If a countdown is paused, press A to reset to the
current countdown start time.
Countdown time
(Minutes, seconds)
7

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Casio-5444

Zoeken resetten

  • Ik wil graag de datum instellen bij mijn Casio no.5444 hoe doe ik dat ? Gesteld op 26-4-2021 om 09:38

    Reageer op deze vraag Misbruik melden
  • Ik krijg mijn horloge ook niet op de mzomertijd, gaat alleen een uur achteruit. Gesteld op 29-3-2020 om 09:45

    Reageer op deze vraag Misbruik melden
  • wie heeft er voor mij voor de casio g-shock 5444 de Nederlandse beschrijving.
    Of wie kan mij zeggen hoe ik de zomer tijd verzet of automatisch in kan stellen.

    gr, Bert Stakenburg Gesteld op 31-3-2019 om 09:15

    Reageer op deze vraag Misbruik melden
  • Wie kan mij de handleiding geven van Casio G-Shock type GST-W110D-2AER.


    Mvgr, Bert Stakenburg e-mail: bertstakenburg@kpnplanet.nl Gesteld op 5-12-2018 om 13:17

    Reageer op deze vraag Misbruik melden
    • Hallo Bert . Na aanleiding van je vraag voor een Nederlandse handleiding voor je Casio G-Shock kan ik je misschien een beetje helpen , ik heb op mijn smartphone de app Google translate o zo gemakkelijk in het buitenland , maar zat ook met het probleem met de handleiding , tot ik probeerde een foto te maken van de handleiding via Google translate en ja hoor een perfecte vertaling in alle talen wat je maar wil , misschien heb je hier wat aan Bert , het werk super . Hoop je een beetje geholpen te hebben hier mee . Groetjes en veel vertaal succes. . Geantwoord op 15-1-2019 om 10:27

      Waardeer dit antwoord (5) Misbruik melden
    • Ja dat klopt Bert , dat het wat meer werk is , ik had het ook graag in het Nederlands naast me liggen , maar we hebben niet veel keus Bert , of het zou een cursus Engels moeten zijn ??Ik pik me gewoon die punten er uit wat ik wil weten op dat moment , de rest scrol ik wel voorbij , mocht bij me nog wat anders invallen laat ik het je wel weten . Groetjes Geert Geantwoord op 15-1-2019 om 13:02

      Waardeer dit antwoord Misbruik melden
  • zou graag een gebruikershandleiding in het Nederlands willen, is dat mogelijk Gesteld op 23-11-2017 om 15:03

    Reageer op deze vraag Misbruik melden
    • helaas heb ik dit horloge ook gekocht en ook geen nederlandse handleiding, is er iemand die weet waar ik mijn klacht in het nederlands kwijt kan bij de casio? Geantwoord op 8-1-2018 om 15:38

      Waardeer dit antwoord (10) Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Casio 5444 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Casio 5444 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,54 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Casio 5444

Casio 5444 Gebruiksaanwijzing - Deutsch - 10 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info