469907
7
Verklein
Vergroot
Pagina terug
1/7
Pagina verder
13
Pace Car function
Pit Stop 30346
300
15 0
250
200
0
100
50
6x CLICK
SPEED
+
CLICK
1 2
3 4
Place car on the track, push lane-change-button twice, lift car at the
front, put car back again (see coding/decoding fi g. 1 + 2).
While car´s lights are fl ashing push lane-change-button 6 times fi g.
1
. Start car, push lane-change-button for requested speed fi g.
2
(irrespective of the car´s position). Car will assume this speed con-
sistently and will enter the next Pit Stop automatically fi g.
3
.
Start Pace Car function:
Start Pace Car by pushing the button at the Black Box fi g.
4
. After
10 seconds each lane switch will change independently until the
Pace Car enters the Pit Stop. Carry out car decoding (see point
coding/decoding).
Setting basic speed
2
1 – 10
1 – 10
3
(individually for one and/or several cars)
Please note the following procedures:
1. Switch off Black Box, place car/s on the track, eff ect coding of
WIRELESS speed controller to speed controller 1 as per point „Cod-
ing/Decoding“.
2. Switch on WIRELESS speed controller located on lower side
(ON/OFF switch).
3. Press and hold lane-change-button during Black Box is switched
on again. Don´t release the lane-change-button until the 1st LED
lights red. Levels are set by pushing lane-change-button. Confi rm
speed by pressing the speed controller´s tappet (thumb) (=> middle
LED will light).
1
+
2
1 LED on = low speed
5 LEDs on = high speed
Setting braking effect
2
1 – 10
1 – 10
3
(individually for one and/or several cars)
Please note the following procedures:
1. Switch off Black Box, place car/s on the track, eff ect coding of
WIRELESS speed controller to speed controller 2 as per point „Cod-
ing/Decoding“.
2. Switch on WIRELESS speed controller located on lower side
(ON/OFF switch).
3. Press and hold lane-change-button during Black Box is switched
on again. Don´t release the lane-change-button until the 1st LED
lights red. Levels are set by pushing lane-change-button. Confi rm
braking eff ect by pressing speed controller´s tappet (thumb) (=>
middle LED will light). Before the start return speed controller to the
original connector!
1
+
2
1 LED on = low braking eff ect
5 LEDs on = high braking eff ec
Setting fuel tank capacity
Pit Stop 30346
1
2
1 – 10
1 – 10
3
(individually for one and/or several cars)
1
Activate fuelling function at the Black Box.
Please note the following procedures:
1. Switch off Black Box, place car/s on the track, eff ect coding of
WIRELESS speed controller to speed controller 3 as per point „Cod-
ing/Decoding“.
2. Switch on WIRELESS speed controller located on lower side
(ON/OFF switch).
3. Press and hold lane-change-button
during Black Box is switched on again. Don´t release the lane-
change-button until the 1st LED lights red. Fuel capacity is set
by pushing lane-change-button. Confi rm by pressing speed con-
troller´s tappet (=> middle LED will light).
Before the start return speed controller to the original connector!
2
+
3
1 LED on = low fuel capacity
5 LEDs on = full tank
Refuelling:
Depending on the fuel capacity the car´s lights start to fl ash after
some time, the car slows down and might start to stutter. For refuel-
ling enter the Pit Stop and release the speed controller´s tappet.
(Fuelling amount depends on car´s standing time in the Pit Stop).
a) Filling up: wait until car´s lights stop fl ashing.
b) Partial refuelling: start while car´s lights still fl ash.
c) Non-refuelling: car drives on at reduced speed.
Maintenance and care
1
2
To ensure a proper operation of the motor-racing circuit, all race-
track components should be regularly cleaned. Pull the plug prior to
cleaning.
1
Racetrack: Keep the track surface and track slots clean with a
dry cloth. Do not use any solvents or chemicals for cleaning. When
it is not in use, store the racetrack in a clean and dust-protected
location, preferably in the original cardboard box.
2
Car check: Clean axle and wheel bearings, pinion gears, gear-
wheels and bearings and lubricate using a resin- and acid-free
grease. You can use a toothpick or similar as aid. Regularly check
the condition of sliding contacts and tyres..
Troubleshooting
Driving tips
Troubleshooting:
In case of any malfunctions, please check the following:
Has the connection to the power supply been established cor-
rectly?
Have transformer and speed controllers been connected
correctly?
Are the track connections faultless?
Are the racetrack and track slots clean and free of any foreign
objects?
Are the sliding contacts in order and do they make contact with
the track slot?
• Are the cars correctly coded to the according speed controller?
• The track‘s current feed will be switched off automatically for 5
seconds, if there is an electrical short circuit: this will be notifi ed by
audible and visual signals.
• Are the cars placed on the track in running direction? In case of
non-functioning push the running direction switch which is on the
car´s bottom.
Please take into account that exposing the Carrera WIRELESS
System for Carrera DIGITAL 124/132 to direct or strong extraneous
light (sunlight, halogen lamps, neon lamps and big fl at screens) may
result in malfunctions.
Double encoding of the speed controllers will be indicated by the
LED fl ashing quickly.
Should operation be impossible despite the speed controllers and
Black Box having being switched on, please check the connection
between Receiver/Tower and Black Box.
In case the receiving radius decreases or the cars´ driving charac-
teristics deteriorate please check the batteries.
Note:
During operation small car parts as spoilers or mirrors may get off or
brake due to being original detailed parts of the car model. To avoid
this it is possible to remove them before operation.
Driving technique:
You can drive fast along the straight track but you should brake
before the curve and then accelerate again when coming out of the
curve.
Do not fasten or block the vehicles when the motor is running:
overheating or damage to the motor could result otherwise.
Note: When using track systems which are not manufactured by
Carrera the existing guide keel has to be replaced by the special
guide keel (#85309). While using the Carrera crossing (#20587) or
high banked curve 1/30° (#20574) slight driving noise might occur
which is due to the full-scale genuineness and does not aff ect fl aw-
less operation.
All Carrera spare parts are available in the webshop:
www.carrera-toys.com
Delivery exclusively to Germany, Austria, Netherlands, Belgium and
Luxembourg..
Technical specifications
Output voltage: Toy transformer
18 V
54 VA
18 V 43,2 VA
Current source speed controller:
6 x 1.5 V Mignon batteries (AA/R6).
Batteries are not included in delivery.
ATTENTION:
It is not possible to use rechargeable batteries.
This device is marked by “selective sort throught” symbol related to
sort through domestic, electric and electronic, waste.
This means the product must be treated by a specialized “sorting/
collecting” system in accordance with European directive 2002/96/
CE, to reduce the impact upon environment.
For more precise information, please contact your local administra-
tion.
Electronical product which are not going through special collect-
ing, are potentially dangerous for environment and human health,
because of dangerous substance.
7

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Carrera Digital 124 - 23605 SPORTSCAR DUEL en WIRELESS bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Carrera Digital 124 - 23605 SPORTSCAR DUEL en WIRELESS in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Pools, Turks, Deens, Zweeds, Noors, Fins als bijlage per email.

De handleiding is 2,13 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info