621065
24
Verklein
Vergroot
Pagina terug
1/25
Pagina verder
47
CHAPTER 15
EN
FAULT
NOTE:
THE MACHINE IS FITTED WITH A SPECIAL ELECTRONIC DEVICE, WHICH PREVENTS THE SPIN CYCLE
SHOULD THE LOAD BE UNBALANCED.
THIS REDUCES THE NOISE AND VIBRATION IN THE MACHINE AND SO PROLONGS THE LIFE OF YOUR
MACHINE.
If the fault should persist, contact a Candy Technical Assistance Centre.For prompt servicing, give the model of
the washing machine, to be found on the label placed on the cabinet inside of the porthole or on the
guarantee certificate.
Important
1 The use of environment friendly detersives without phosphates may produce the following effects:
- The discharge rinse water may result cloudier due to the presence of zeolites in suspension. This does not
compromise the efficiency of the rinses.
- The presence of white powder (zeolites) on the washing at the end of the washing cycle. This does not
remain incorporated in the fabric and does not alter the colour.
- The presence of foam in the last rinse water which is not necessarily a sign of inadequate rinsing.
- The non-ionic surface-active agents present in the composition of washing machine detersives are often
difficult to remove from the washing itself and, even in small quantities, may produce visible signs of the
formation of foam.
- Carrying out further rinses, in cases such as this, is not useful.
2 If your washing machine fails to function, carry out the above-mentioned checks before calling the Candy
Technical Assistance Service.
1. Does not function
on any
programme
2. Does not load
water
3. Does not discharge
water
4. Water on floor
around washing
machine
5. Does not spin
6. Strong vibrations
during spin
Mains plug not plugged in
Mains switch not on
No power
Electric circuit fuses failure
Load door open
See cause 1
Inlet tap turned off
Timer not set correctly
Discharge tube bent
Leak from the washer between the tap
and inlet tube
The washing machine has not
discharged water
“No spin” setting (some models only)
Washing machine not perfectly level
Transport bracket not removed
Washing load not evenly distributed
Insert plug
Turn on mains switch
Check
Check
Close load door
Check
Turn on water inlet tap
Set timer on correct position
Straighten discharge tube
Replace washer and tighten the tube
on the tap
Wait a few minutes until the machine
discharges water
Turn the programme dial onto spin
setting
Adjust special feet
Remove transport bracket
Distribute the washing evenly
CAUSE
REMEDY
Advisory note
During drying phase the drum will accelerate to a higher speed to distribute the load and to
optimize the drying performance
46
CHAPITRE 15
ANOMALIE
Si le mauvais fonctionnement persiste, adressez-vous au Centre d’Assistance Technique Candy; communiquez
le nom du modèle indiqué sur la plaquette se trouvant sur la carrosserie à l’intérieur du hublot ou sur le bulletin
de garantie.
En indiquant ces informations vous obtiendrez une intervention plus rapide et efficace.
1 L’utilisation des produits écologiques sans phosphates peut produire les effets suivants:
- L’eau de vidange du rinçage est trouble à cause de zéolites en suspension; l’efficacité du rinçage n’est
absolument pas compromis;
- Présence de poudre blanche (zéolites) sur le linge à la fin du lavage: cette poudre ne pénètre pas dans le
tissu et n’en altère pas la couleur;
- présence de mousse dans l’eau du dernier rinçage: elle ne signifie pas pour autant un mauvais rinçage;
- Les tensioactifs anioniques de la formule des produits pour machines à laver, s’enlèvent difficilement du linge
et, même en toute petite quantité, ils peuvent provoquer d’importants phénomènes de formation de mousse;
- L’exécution d’autres cycles de rinçage, en de tels cas, n’apporte aucun avantage.
2 Avant d’appeler le Centre d’Assistance technique Candy, si votre machine ne fonctionne pas, effectuer les
contrôles susmentionnés.
NOTE:
LA MACHINE EST DOTEE D’UN DISPOSITIF ELECTRONIQUE QUI EMPECHE LE DÉPART DE
L’ESSORAGE SI LES CHARGES SONT MAL REPARTIES ET LIMITE LES VIBRATIONS ET LE BRUIT DURANT
LE LAVAGE.
1. Aucun
fonctionnement
sur n’importe quel
programme
2. Absence
d’alimentation
d’eau
3. L’eau n’est pas
évacuèe
4. Présence d’eau sur
le sol tout autour
de la machine
5. La machine
n’essore pas
6. De fortes vibrations
pendant la phase
de centrifugation
La fiche n’est pas introduite dans la
prise de courant
L’interrupteur géneral n’est pas branché
L’énergie électrique est coupée
Les valves de l’installation électrique
sont défectueuses
Portillon ouvert
Voir cause 1
Robinet de l’eau fermé
Programmateur mal positionné
Tuyau de vidange plié
Fuite du joint se trouvant entre le robinet
et le tuyau de remplissage
La machine n’a pas encore évacué
l’eau
La fonction “suppression d’essorage” est
introduite (exclusivement sur certains
modèles)
La machine n’est pas à niveau
Les étriers de transport n’ont pas été
enlevés
La charge de linge n’est pas répartie
de façon uniforme
Brancher la fiche
Brancher l’interrupteur général
Contróler
Contróler
Fermer le portillon
Contróler
Ouvrir le robinet d’alimentation d’eau
Positionner correctement le timer
Redresser le tuyau de vidange
Remplacer le joint et serrer à fond le
tube sur le robinet
Attendre quelques minutes et la
machine évacuera l’eau
Relever la touche “exclusion
centrifugation”
Régler les pieds
Enlever les étriers de transport
Répartir le linge de façon uniforme
CAUSE
REMEDE
FR
Note d’information
Pendant la phase de séchage, le tambour effectue des rotations à grande vitesse pour brasser
le linge et ainsi optimiser le cycle.
24

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Candy CDB 465 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Candy CDB 465 in de taal/talen: Engels, Frans als bijlage per email.

De handleiding is 2,53 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info