GB USER MANUAL
10
DISC CANNOT BE PLAYED
• Ensure the disc is label side up.
• Clean the disc.
• Check if the disc is defective by trying another disc.
• Check the type of disc you put into the player.This player only plays DVD-R/DVD+R/
DVD-RW/DVD+RW/ VCD/S-VCD/CD/CD-DA/CD-RW/MP3
• Both the player and the disc are coded by region. If the regional codes don’t match, the disc
can’t be played.
DISTORTED PICTURE
• Check the disc for fingerprints and clean with soft cloth, wiping from center to edge.
• Sometimes a small amount of picture distortion may appear.This is not a malfunction.
• Interfered by short-distance strong interference (E.g. high voltage wire, transformation station
or aircraft etc.). Move the vehicle away from the interference.
THE PICTURE ON THE SCREEN IS DARK
• This is the characteristics of TFT display in low temperature, it will restore to normal
brightness after starting the display for few minutes.
• Adjust the brightness settings.
NO SOUND CAN BE HEARD FROM THE IR WIRELESS HEADPHONES
• Turn on the Headphones.
• The battery in the headphone is low.
• Avoid all obstacles which may interfere with the signal path.
PICTURE SKIPS OCCASIONS
• Clean the disc or check if the disc is defective by trying another one.
THE PLAYER DOES NOT RESPOND TO THE REMOTE CONTROL
• Aim the remote control directly at the sensor on the front of the player.
• Avoid all obstacles which may interfere with the signal path.
• Inspect or replace the batteries.
• Clean the IR sensor from the remote control and DVD player.
BUTTONS DO NOT WORK
• Unplug the player from power outlet and reconnect after a few seconds.
WIRING AND CONNECTIONS (ILL. E)
1. Battery + lead (yellow) To connect the positive terminal of the car battery.
2. ACC power lead (red) To ACC power lead powered when engine key position is ACC.
3. Ground lead (black) Connect the lead to a good chassis ground on the car. Make sure the
connection is made to bare metal and is securely fastened using the
sheet metal screw provided.
4. Door wire (green) Connect this wire to the door sensor of the car. then the dome light
can be switched by opening or closing door.
PLEASE NOTE
Please slide the polarity switch to ”-” at the left position if your vehicle’s door trigger is negative;
please slide the polarity switch to ”+” at the right position if your verhicle’s door trigger is positive.
NOTE:• Please slide it to a side fully.
• Do not slide this switch after place it at a position. Otherwise, it’ll be damage.
5. FM Antenna This antenna send the signal to the FM receiver.
6. AUX A/V, input 1
7. AUX A/V, input 2
8. AUX A/V, output An auxiliary A/V output is provided to drive an external monitor.This
signal mirrors what’s being shown on this player.The volume function
does not affect the auxiliary A/V output.
CONNECTING TO USB OR MEMORY CARD (ILL. F)
Insert the USB stick/memory card into the USB/memory terminal of the player.When the unit sets in
DVD mode, pressing SRC button on the remote control for more than 1 second to change the mode
from DVD to USB/memory card,The main unit will read the USB stick/memory card automatically.
NOTE: • The USB terminal only supports USB 1.1.
• Please insert the memory card in the right direction.
• Some kind of USB sticks/memory cards can not be used in this player.
CUSTOMIZING DVD SETTINGS (ILL. G)
Press the SETUP button on the remote control to open the DVD setup menu.With the ”<”,
”>”, ” ”, ” ” and ENTER button you can change the settings.
TROUBLESHOOTING
If it appears that your DVD-Video player is faulty, first consult this checklist. It may be that
something simple has been overlooked. Under no circumstances should you try to repair the
player yourself; as this will invalidate the warranty. Only qualified service personnel can remove
the cover or service this player.
PLAYER WON’T WORK
• Press the Reset button on the front panel of the DVD player.
DVD PLAYER DOESN’T TURN ON
• Check the on/off button.
• Check if power plug is properly connected.
• Check if there is power at the AC outlet by plugging in another appliance.
• Condensation in the player, wait one hour or until condensation evaporates.
THE DVD PLAYER SUDDENLY STOPPED WORKING OR THE SCREEN WENT BLACK
•Try turning the player off and on. If the player still doesn’t respond, press the reset button.
PLAYER OPERATES ERRATICALLY
• Check and tighten all connections.
GB USER MANUAL
9
