647579
39
Verklein
Vergroot
Pagina terug
1/44
Pagina verder
Faults and what to do about them en
39
Faults and what to do about them.
Faults Cause/Remedy
Water is leaking from the
appliance.
Attach the drain hose correctly or replace it.
Tighten the screw connection of the drain hose.
The machine is not filling
with water.
Detergent is not being dis-
pensed.
Have you pressed the Inicio/Pausa A (Start/Reload) button?
Is the tap turned on?
Could the filter be clogged? Clean the filter. ~ Page 36
Is the supply hose kinked or trapped?
The door cannot be
opened.
The safety function is activated.
Note: For safety reasons, the washing machine door remains locked when
the water level or temperature is high (see ~ "Cancelling the programme"
on page 31) or while the drum is rotating.
Is - - - (Rinse Stop = no final spin) selected? ~ Page 31
Can the door only be opened by the emergency release? ~ Page 37
The programme will not
start.
Have you pressed the Inicio/Pausa A (Start/Reload) or Ready in button?
Is the door closed?
Is the childproof lock E activated? Deactivate it. ~ Page 30
The drum briefly jerks or
judders after the pro-
gramme has started.
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash programme starts.
The water is not draining. Is - - - (Rinse Stop = no final spin) selected? ~ Page 31
Clean the drain pump. ~ Page 35
Clean the drain pipe and/or the drain hose. ~ Page 36
Water is not visible in the
drum.
Not a fault – the water is below the visible area.
The spin result is not sat-
isfactory.
Laundry is wet/too damp.
Not a fault – the unbalanced load detection system has interrupted the spin
cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
Easy-Iron* selected? ~ Page 27
Is the selected speed too low?
The spin cycle runs sev-
eral times.
Not a fault – the unbalanced load detection system is adjusting an imbalance.
The programme is taking
longer than usual.
Not a fault – the unbalanced load detection system is adjusting an imbal-
ance by repeatedly distributing the laundry.
Not a fault – the foam detection is system active – a rinse cycle has been
switched on.
The length of the pro-
gramme changes during
the wash cycle.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown in the display
panel.
* depending on the model
39

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Bosch-WAN24260

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bosch WAN24260 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bosch WAN24260 in de taal/talen: Engels als bijlage per email.

De handleiding is 4,18 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info