DIGISTAT
INSTALLATION
DIGISTAT / DT20RF RECEIVER
TO CHECK PREVIOUSLY
INSTALLED UNIT
Signal strength indicators
Transmitter code
(may be different)
LED indicator shows different colour depending
on signal strength (see table below)
LED Indication Chevrons RF Strength
Green
Amber
Red
None
4
3
2
1
Very strong
Strong
Weak
Very weak
To cancel signal strength mode:
1. Remove the batteries from the transmitter to
cancel the constant transmission.
2. After a few seconds the receiver display will show
‘---’ .
3. Press ‘OK’ on the receiver display and the display
will return to the time with the ‘CH and Antenna’
flashing.
4. Re-insert the batteries into the transmitter and the
RF link will be re-established.
OPERATING & INSTALLATION
INSTRUCTIONS
DT20RF PROGRAMMER
INSTRUCTION MANUAL
8 716 115 495a (02.2009)
26