must be used on a level, stable, non-flammable
surface. The appliance should be protected
from direct draughts and shall be positioned
or protected against direct penetration by any
trickling water (e.g. rain). I fused on a wooden
table the table must be protected with a non-
flammable covering to avoid any discolouring of
the wood.
Parts sealed by the manufacturer or his agent
must not be altered by the user. No modifica-
tions should be made to any part of this barbe-
cue and repairs and maintenance should only
be carried out by a Boretti service engineer.
Connection to Appliance
Connect the gas tap to the appliance by follow-
ing instruction 1 in the lighting instructions.
Before connection, ensure that there is no de-
bris caught in the head of the gas cylinder, reg-
ulator, burner and burner ports. Spiders and
in sects can nest within and clog the burner/
venturi tube at the orifice. A clogged burner
can lead to a fire beneath the appliance.
Clean burner holes with a heavy-duty pipe
cleaner. Fit the hose to the appliance using a
crimp clip or jubilee clip. If the hose is replaced
it must be secured to the appliance and regula-
tor connections with hose clips.
Disconnect the regulator from the cylinder
(according to the directions supplied with the
regulator) when the barbecue is not in use.
The Barbecue must be used in a well ventilated
area. Do not obstruct the flow of combustion
air to the burner when the barbecue is in use.
ONLY USE THIS BARBECUE OUTDOORS
BEFORE USE CHECK FOR LEAKS
Never check for leaks with a naked ame,
always use a soapy water solution.
To check for leaks
Make 2-3 fluid ounces of leak detecting solu-
tion by mixing one part washing up liquid with
3 parts water.
Ensure the control valve is “OFF”
Connect the regulator to the cylinder and ON/
OFF valve to the burner, ensure the connec-
tions are secure then turn ON the gas.
Brush the soapy solution onto the hose and all
joints. If bubbles appear you have a leak, which
must be rectified before use.
Retest after fixing the fault.
Turn OFF the gas at the cylinder after testing.
If leakage is detected and cannot be rectified.
Do not attempt to cure leakage but consult
your gas dealer.
Lighting your barbecue
Lighting Instructions:
1. Connect the Needle valve to the appliance
by screwing the injector on the end of the
gas tap into the end of the burner tube in
the right hand end of the barbecue. Turn the
needle valve clockwise to “OFF” position.
2. Connect the regulator to the gas bottle. Turn
the gas supply “ON” at the regulator. Check
with the use of soapy water for any gas leak-
age between the bottle and the regulator.
3. Open the hood, turn on needle valve, whilst
applying a match to the lighting hole in the
right hand side of the barbecue. Turn the
needle valve anti-clockwise to the “Full rate”
position. Keep the match in the lighting hole
until the burner lights. Do not hold the match
in the hole for longer than 5 seconds.
4. If the burner has not lit wait 5 minutes and
