552136
6
Verklein
Vergroot
Pagina terug
1/9
Pagina verder
6
11/2012
R
EVERSE
T
HE
D
OOR
O
PENING
If required, the door opening can be moved from the right (supplied condition) to the left side.
WARNING
When replacing the door, the device must be disconnected from
the power supply. Always unplug the device first.
1. Use a small flat screwdriver to lift up the two screw covers
(1) on the top cover (3).
2. Use a cross screwdriver to remove the two screws (2) on the
top cover and the other two screws (11) on the backside of
top cover.
3. Lift up the top cover (3) and pull out the door hinge pin (4)
from the door, and put them on a safety place for later use.
Lift up the door (6) and put it on a safety place for later use.
4. Remove the left adjustable foot (7) and the right adjustable
foot (8) and screws (9) and keep them for later use.
5. Move the lower hinge (10) from the right side to the left side,
then fix it with the screws (9). Then install the right adjustable
foot (8) on the left and the left adjustable foot (7) on the right.
6. According to the reversible way of above procedure to install
the door (6), then put the door hinge pin (4) into the left hole
of the door, then put the top cover (3) on it, please make sure the door hinge pin (4) to be placed
into the hole of the top cover (3), then use the cross screw drive to fix the screws (2) and the
screws (11), finally put the screw covers (1) on it.
Check if the door is arranged vertical as well as horizontal, so that a smooth opening and closing of
door is ensured.
S
TARTUP
/
O
PERATION
Prior to First Use
ATTENTION: After transport, the device should be left standing for 4 hours in order for the oil to
be collected in the compressor.
Nonobservance could cause damage to the compressor and hence
result in failure of the device. This would void your warranty claim.
- Clean the interior of the device including all accessory parts located inside.
Connect the Device to the Mains Supply
IMPORTANT
- The device must be earthed properly. For this purpose the plug of the mains cable has been fitted
with the intended lead.
- Contact an electrician if the plug does not fit in the wall socket.
- In case you disconnect the device or in case of power failure: Wait for 5 minutes before restarting
the device.
Operation
Turn on the device by connecting the plug to a wall socket and turning the temperature control, which
is located at the right side of the fridge interior. Please also refer to chapter ‘Settings’.
Settings
Setting 0 – OFF indicates the device is turned off.
Turn the temperature control clockwise, starting from this setting; the device will turn on automatically.
The Settings 1 MIN 7 MAX regulate the inside temperature. When opening the door, the interior
lamp will turn on.
Setting 0 (or OFF) = Off
Setting 1 (or MIN) = lowest setting (warmest inside temperature)
Setting 7 (or MAX) = highest setting (coldest inside temperature)
6

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bomann VS 264 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bomann VS 264 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,46 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Bomann VS 264

Bomann VS 264 Gebruiksaanwijzing - Deutsch - 10 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info