5
ENGLISH
The unit must be disconnected
from the mains supply and
taken to an authorised service
centre for repair.
The charger is intended for
indoor use only.
Read the manual carefully
before using the appliance.
Warning! Keep electrical appliances out
of reach from children or infirm persons.
Do not let them use the appliances
without supervision.
Features
1. On/off switch
2. Dust bowl
Fig. A
3. Crevice tool
4. Brush tool
Unpacking
Identifying your product
The model design can be determined from
the suffix codes used in the catalogue
number. The following catalogue
numbers are described in this manual:
NV19XXY/NV24XXY/NV36XXY/
NV48XXY/NV60XXY/NV72XXY
The suffix code XX corresponds to the
following designs:
00/99: stick handle, no accessories supplied
03: loop handle, supplied with crevice
tool and brush tool
The suffix code Y is used to identify the
range of colour options. The suffix code
Y represented by the letter N is used for
models with an NiMH battery.
Installation
NV24XXY/NV36XXY/NV48XXY/
NV60XXY/NV72XXY - Fitting the
charging base to the wall
(fig. B1 & B2)
The charging base can be placed on
a worktop or fitted to the wall to provide
a convenient storage and charging point
for the appliance.
Assembly
Fitting the accessories (fig. A & C)
Depending on the model, the appliance
is supplied with the following accessories:
a crevice tool (3) for confined spaces
a brush tool (4) for furniture and stairs
To fit an accessory, proceed as follows:
Take the accessories from the
appliance.
Insert the appropriate accessory into
the front of the appliance.
You may refit the other accessory by
clicking it into the accessory holder.
To refit both accessories:
Push the accessories down until they
click into place.
Use
The appliance can be charged while
placed on a worktop or hung on the
wall using the wall hook provided.
Before first use, the battery must be
charged for at least 16 hours.
Leave the appliance connected to the
charger whenever it is not in use.
Charging the battery (fig. B1 - B3)
NV24XXY/NV36XXY/NV48XXY/
NV60XXY/NV72XXY (fig. B1 & B2)
Make sure that the appliance is
switched off. The battery will not be
charged with the on/off switch in the
on position.
Fit the appliance properly on the
charger aligning the arrow on the
charger with the split of the appliance.
Plug in the charger. Switch on at the
mains.
Leave the appliance to charge for at
least 16 hours.
NV19XXY (fig. B3)
Make sure that the appliance is
switched off. The battery will not be
charged with the on/off switch in the
on position.
Insert the charger plug (6) into the
charger connector (7) at the rear of
the appliance.
Plug in the charger (5). Switch on at
the mains.
