747164
8
Verklein
Vergroot
Pagina terug
1/11
Pagina verder
Radio module features
This smoke alarm is equipped with a radio module that:
Transmits radio signals to up to 40 interconnected smoke alarms.
Transmits radio signals to one or several supplementary Visit receivers. A Visit receiver
will help hard of hearing and deaf people to notice the alarm. The alert type and signal
pattern for the Visit receiver is found in the products user manual.
Radio channel/key
This smoke alarm transmits on a xed radio channel/radio key. So, no matter what radio
key your Visit receiver is set to, it will respond to the alarm if it’s within radio range.
Radio range
The operation range between a smoke alarm and an interconnected unit or Visit receiver is
over 100 m free eld but is inuenced by the thickness of the walls and the wall materials in
the house or apartment. The range will also be also be reduced if the smoke alarm battery
level is low. Check that the Visit receivers and interconnected units responds to the smoke
alarm signal everywhere in the house or apartment. The bedroom is most important.
1514
Test and maintenance
Your smoke alarm is a life saving device and should be tested periodically. Regularly check
that the red LED on the smoke alarm blinks every 40 s to show that the unit is powered.
Testing your smoke alarms
It is recommended that you test your smoke alarms after installation and then at least
weekly to ensure the units are working.
Press and hold the test button until the alarm sounds. If there is no sound, the battery,
horn or circuity could be defected, please read the 'Troubleshooting' section for advice.
If you have interconnected smoke alarms, they will sound for 10s and blink fast for 5 min.
To mute them, press the test button on each unit.
If the smoke alarm is connected to a supplementary Visit receiver, check and make sure
that the Visit receiver reacts too. See the 'Quick start guide' section and the Visit receiver
user manual. The Visit receiver will stop signalling within 40s.
Repeat this procedure for all non-interconnected smoke alarms in the system.
Warning: Do not test with an open ame. You could damage the alarm or ignite combustible
materials and start a re. When you press the test button it simulates the eect of smoke in a
smoke alarm which it could experience in a real re. So, there is no need to test smoke alarms
with smoke or ame.
Cleaning your smoke alarm
Clean your smoke alarm regularly. Use a soft bristle brush or the brush attachment of your
vacuum cleaner to remove dust and cobwebs from the side slots where the smoke enters.
To clean the cover, wipe with a damp cloth and dry thoroughly.
Important: Do not attempt to remove the cover to clean the inside. This will aect warranty.
Warning: Do not paint your smoke alarm. Other than the maintenance and cleaning described
in this leaet, no other customer servicing of this product is required. Repairs, when needed,
must be performed by the manufacturer.
Inteconnected smoke alarms
Cause Status LED Sound
Alarm Chirps twice every s
Low battery Blinks once every 3 h Chirps once every 3 h
Test Blinks twice every s Chirps twice every s
Signal pattern – interconnected units
Depending on the cause of the alarm, the interconnected smoke alarms will signal as follows:
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bellman BE1289 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bellman BE1289 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,26 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info