2
1
Belinea 10 17 25 - Operating Instructions - 4
ENGLISH
VGA Cabel with
integrated audio
cable
Carefully lift the monitor out of the packaging and make
sure that all components are included (see fig. 1).
Save the original box and packing material in case you
have to ship or transport the monitor.
To set up the device, you must fit the monitor base
together.
UNPACKING
Power cord
To connect the monitor to your PC .........................
1. Make sure that the PC and monitor are unplugged.
2. Connect the 15-pin signal cable to the PC (see fig.
2).
CONNECTING
Connecting the audio cable ....................................
If your computer is equipped with audio output capabi-
lities, connect the VGA cable’s integrated audio cable
into the “line out” jack of the PC.
To connect the monitor to the power source ........
1. Connect the power cable (
in fig. 3) to the monitor’s
power jack (
in fig. 3).
2. Plug the power cable (
in fig. 3) into a socket.
Figure 1. LCD Monitor
Figure 2. Connecting the monitor to the PC
Signal cable
Figure 3. Connecting the monitor to the power source
1. First start your PC and then turn on your Belinea
monitor using the power switch (
in fig. 4). The
power indicator (
in fig. 4) should light up green.
2. Adjust the image to meet your requirements (see the
following sections “Basic Setup” and “Image settings
using the OSD menu”).
3. If there is no image displayed on the monitor, consult
the section “Troubleshooting”.
STARTUP
