- 3 -
Warning:
- The smokemachine must be placed at least 100 cm away from inflammable materials such as curtains,
books, etc. Make sure that the housing cannot be touched by accident.
- Use only Beamz water-based smoke fluid recommended by your dealer.
- Poor smoke liquid caused permanent damage, bad effect, clogging, spitting of unevaporated liquid etc.
- Never add flammable fluids (oil, gas, perfume) to the fog liquid.
- Always keep enough smoke liquid in the tank.
Use of the device without liquid will cause damage to the pump and heater.
- Do not obstruct the openings on top of the case to guarantee a good ventilation.
- Don’t put any objects on the smoke machine.
- For indoor use only.
- During installation, nobody should stand beneath the mounting area.
- Prior to the first use, have the unit checked by a qualified person.
- The unit contains voltage carrying parts. DO NOT open the smokemachine
- Never plug or unplug the unit with wet hands.
- If the plug and/or mains lead are damaged, they need to be repaired by a qualified technician.
- If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a mains outlet. It
needs to be repaired by a qualified technician.
- Only connect this unit to an earthed mains outlet of 220-240Vac/50Hz .
- Always unplug the unit during a thunderstorm or when it is not in use.
- If the unit has not been used for a longer period of time, condensation can occur inside the housing. Please
let the unit reach room temperature prior to use.
- When you unplug the unit from the mains always pull the plug, never the lead.
- In order to prevent dropping of the unit, a safety fastening needs to be installed. This can be a solid chain, a
steel cable, etc. which has to be fastened separately from the mounting bracket.
- The supplied bracket is the main fixing and must be used to solidly mount the light effect.
- In order to avoid accidents in public premises, the local legal requirements and safety regulations/warnings
must be fulfilled.
- Keep out of the reach of children.
Location
Select a location where it is easy to fill the tank.
Installation and Use
Unpack the fog machine. Do not connect yet the net cable. Fill the fluid tank by means of a funnel. Fill the ice
tray with ordinary ice. Close the drain valve off. (Once ice has melted, you can drain the water here.) When the
machine is filled with ice, the lid can be closed.
Attention:Drain the water, melted ice regularly. (approximately every 45 minutes)
Plug the unit into a mains outlet. Thus the heating element is automatically switched on. Depending on the room
temperature, it takes about 5 minutes until the working temperature is reached. Then the thermostat is clicking
and the LED on the manual control lights up. Push the switch once and the smoke machine will produce a nice
thick fog. Once the smoke machine has reached its working temperature (the LED is lit) the smoke machine can
produce fog for a while. After this period of time, the fog generator is cooled so much down that the thermostat
switches off. Wait a while until the working temperature is reached again. It is recommended to produce smoke
with small pauses in between so that the temperature is maintained and the thermostat doesn’t switch off.
Make sure that there is always enough liquid smoke contained in the tank. Use of the smoke machine without
liquid can permanently damage the unit. Once the smoke machine generates little smoke or pump generate
another 'rattling' sound i turn off the unit direct. Check the fluid level and fill the tank when it is empty, check the
hose and filter blockages and restore it. Plug in the unit and check if the problem is resolved. If problem persists,
switch unit direct off to prevent further damage and contact your dealer.
Switching the unit off
Switch the unit off by unplugging it from the mains. Otherwise the 1200W heating element will draw
unnecessarily current.