309228
2
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
5019 412 10045
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the
values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
* The remaining time indicator can similarly deviate from the values in the table, because it takes into account the
household conditions applicable at that time.
** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump
drains the water out.
*** Reference programme for Energy label.
1. Close the drum doors and check that they are
properly locked.
2. Add detergents and additives into the dispenser to
no more then the
“MAX”
level mark, as follows:
Programme with pre and main wash
Main wash programme without prewash
Fabric softeners and conditioners
Chlorine bleach
Stain remover agents
Anti-scale agents (if necessary)
3. Turn the
programme selector knob
to the
desired programme.
The remaining time display shows the duration of the
chosen programme (in hours and minutes) and the
indicator light of the
“Start/Pause”
button flashes.
The programme sequence and the predefined
spin speed indication corresponding to the
selected programme lights up.
The preselected temperature can be altered by
pressing the “+” or “-” button.
When you select an option authorized by the
programme, the corresponding indicator lights up,
except if the combination of programme,
additional options and temperature is not possible.
“Easy Ironing” button
Can be used together with “Cotton”, “Synthetics” and
“Daily Mixed” programmes to make ironing easier.
Increases the water quantity in rinsing and the
clothes are spun in a softer manner.
“Prewash” button
Only for heavily soiled loads
(for example sand, granular dirt).
“Intensive Rinse” button
The amount of water is increased to ensure a
more intensive rinse.
This option is particularly suitable for areas with
very soft water or washing linen laundry for
people with skin allergies.
“Rinse Hold” button
The laundry remains in the last rinse water
without progressing to the final spin cycle to
avoid creasing and prevent colours from fading.
This option is particularly recommended for the
“Synthetics”, “Delicates” and “Daily Mixed”
programmes.
This function is particularly useful if you want to
postpone spinning to a later time, or if you want
to drain only.
Note:
The programme with “Rinse Hold” stops
when the “Rinse Hold” indicator light flashes on the
“Programme Sequence Indicator”.
CONSUMPTION DATA
Programme
Temperature
Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)*
Cotton / Hygienic+ 95 5.0 49** 1.60 2:05
Cotton *** 60 5.0 48 0.85 2:15
Coloured Cotton 40 5.0 48 0.60 2:00
Synthetics 60 2.0 55** 0.70 1:30
Synthetics 40 2.0 50 0.50 1:15
Daily Mixed 40 3.0 45 0.45 1:00
Delicates 40 1.5 50 0.50 0:45
Rapid 30 3.0 35 0.40 0:30
Wool 40 1.0 55 0.60 0:45
Handwash 30 1.0 40 0.40 0:35
PREPARATION OF WASH CYCLE
SELECT THE DESIRED OPTION
Appliance in “Rinse Hold”:
Press the “Rinse Hold” button again: the
programme will terminate automatically with the
selected spin cycle.
If you do not wish to spin the clothes, turn the
programme selector knob to the “Drain /
Reset” programme and press the
“Start/
Pause”
button again.
“Spin Speed Reduction” button
Every programme has an automatically allocated
maximum spin speed.
Press the button to set another spin speed.
If the spin speed “
0
” is selected, the final spin is
cancelled, but not the intermediate spins. The
programme ends with a drain cycle.
The “Start Delay” button allows the user to run the
machine at his convenience, for example at night
when electricity is cheaper.
Select programme, temperature and options.
Press the “Start Delay” button several times to
select the delay time by 1 to 19 hours;
•Press the
“Start/Pause”
button. The indicator
light of the
“Start/Pause”
button lights up and
the lamp of the “Start Delay” button flashes.
The time delay indication disappears when the
programme starts and is replaced by the
remaining time.
The number of hours preselected can be reduced
later by pressing the “Start Delay” button again.
To cancel the “Start Delay” option
Turn the programme selector to the “ ” position.
Reselect the desired programme and options
and press the
“Start/Pause”
button.
Turn on the tap and press the
“Start/Pause”
button. The indicator light of the
“Start/Pause”
button lights up. The indicator lamp shows the
sequence reached by the programme. After starting
the programme, the programme sequence indicator
signals the Wash, Rinse and Spin phases.
Note
: If there is a power interruption or if the
appliance is disconnected during the cycle, the
programme will run again from the point where it
was interrupted.
For safety reasons, the lid is locked during certain
phases of the cycle. At the end of the cycle or during
an interruption, the lid unlocks automatically after
about 1 minute.
The remaining time is on “0: 00” and the “End”
lamp lights up.
1. Turn the programme selector to the “
position.
2. Turn the tap off.
3.
Open the lid and the drum doors and unload the
machine.
1. Select the new programme using the
programme selector. If necessary, select the
additional options and the spin speed. The
luminous indicator of the
“Start/Pause”
button flashes.
Note: the “Start Delay” and “Prewash” options
cannot be selected after a programme change.
2.
Press the
“Start/Pause”
button. The new
programme selected continues at the same
position where the previous programme was
interrupted.
Note:
Do not add detergent for this
programme.
If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:
1. Press the
“Start/Pause”
button. The light
flashes.
2. After the desired pause, press again on the
“Start/Pause”
button.
1. Set the programme selector to “Drain / Reset”.
2. Press the
“Start/Pause”
button to start the
“Drain / Reset” programme.
START DELAY
PROGRAMME START
LID LOCK
END OF WASH CYCLE
CHANGE THE PROGRAMME OR OPTIONS
DURING THE CYCLE
PAUSE/INTERRUPT A PROGRAMME
CANCEL PROGRAMME
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bauknecht wate 9573 3 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bauknecht wate 9573 3 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,17 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info