Handleiding Bauknecht WAT PLATINUM 781 (pagina 2 van 2) (Engels)

723098

Verklein

Vergroot

Pagina terug

1/2

Pagina verder

CONSUMPTION DATA

Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect

to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.Water and energy consumption refer to the

default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data.

The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also

“Troubleshooting Guide” in your Instructions for Use).

* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

** Standard Cotton programme and basis for Energy Label. For reasons of energy saving, the real water temperature may deviate from the declared cycle temperature.

*** After programme end and spinning with maximum selectable spin speed, in default programme setting.

Power consumption in off-mode 0.11 W / in left-on mode 0.11 W

CHILD LOCK BUTTONS

You can lock the buttons of the control panel against

improper use (e.g. by children).

• Press both of the child lock buttons simultaneously and

hold them for at least 3 seconds.

• To unlock the buttons again: proceed in the same way.

FAILURE INDICATIONS

In case of any failures or irregularities, consult the

“Troubleshooting Guide” in your Instructions for Use.

“Water tap closed” - no or not sufficient inlet water.

“

Service” - failure or malfunction of an electrical

component.

“Clean pump” - waste water is not pumped out.

Spin speed on display blinks: unbalance during spinning

•

PROGRAMME END

The “Lid open” indicator lights up, and the display shows

“End”. After about a quarter of an hour, the washing

machine will switch off completely to save energy.

1. Turn the programme selector to the “O” position.

2. Close the water tap.

3. Open lid and drum and unload the machine.

4. Leave the lid open for some time to allow the interior of

the machine to dry.

DETERGENT OVERDOSAGE INDICATION

The symbol will light up at the end of the programme if you

used too much detergent. use less detergent next time. If the

symbol lights up and the display shows “Fod”, too much foam

interrupted the wash process; refer to the “Troubleshooting

Guide” in your Instructions for use.

CHANGE PROGRAMME AND/OR OPTIONS AF-

TER PROGRAMME START

Press the “Start/Pause” button to pause the

programme. The light blinks.

2. Select the new programme, temperature, any options and

another spin speed if you want.

3. Press the “Start/Pause” button again. The new

programme continues at the same position where the

previous programme was interrupted. Do not add

detergent for this programme.

CANCEL A RUNNING PROGRAMME BEFORE THE END

The “Reset/Drain” button cancels a programme before the

end.

• Press the “Reset/Drain” button for at least 3 seconds.

The water is drained out; it may last a while until you can

open the lid.

“Fresh Finish” button

• Select this option if you cannot unload the laundry soon

after programme end, or if you tend to forget the laundry

in your washing machine. It will help to keep your laundry

fresh.

• The washing machine will start to tumble the laundry

periodically after programme end.

• The light of the “Fresh Finish” button will blink while this

function is active, and the display will show an animation.

• The periodic tumbling will last up to approximately 6

hours after the end of your wash programme, and you can

stop it at any time by pressing the “Fresh Finish” button. It

will last a while until you can open the door.

• After the “Fresh Finish” period has run out, the display

indicates “End”.

“Rapid” button

• Enables quicker washing by shortening the programme

duration.

• Recommendable for small loads or only lightly soiled

laundry.

“Prewash” button

• Only for heavily soiled loads (for example sand, granular

dirt). Increases the cycle time by approximately 15 min.

• Do not use liquid detergent for the main wash when

activating the Prewash option.

“Intensive rinse” button

• More water is added and rinse cycle is prolonged.

• This option is particularly suitable for areas with very

soft water, washing baby linen and helping people with

allergies.

“Spin” button

• Every programme has a predefined spin speed.

• Press the button to set another spin speed.

• If you select spin speed “0”, the final spinning is cancelled

and the water is drained out only. However, intermediate

spin phases remain during the rinse.

PREPARATION OF THE WASH CYCLE

Load the washing machine, close the drum door and

check that it is closed properly.

2. Pour in the detergent and any additives, as described

overleaf and in the instruction manual.

3. Close the lid.

4. Turn the programme selector to the desired

programme. The display shows the duration of the

selected programme (in hours and minutes), and the

indicator for the “Start/Pause” button flashes. The

temperature and spin speed can be changed by pressing

the “Temperature” and “Spin” buttons. If you do not start

the programme soon after having made your choice, the

washing machine will switch off automatically after about

a quarter of an hour. Switch on the washing machine again

by turning the programme selector back to “O” and then

to the desired programme.

SELECT ANY DESIRED OPTION

When the combination of programme and additional option(s)

is not possible, the indication lights switch off automatically.

Unsuitable combinations of options are deselected

automatically.

“15° Green&Clean” button

• Enables ecological washing by saving energy used for

waterheating, while maintaining a good wash result.

• Bright colours live longer with this option.

• Recommendable for lightly soiled laundry without stains.

• Use special cold wash detergents with this option to

enable a good wash result.

• Not selectable for Cotton 70 - 95°C.

SAVE YOUR FAVOURITE PROGRAMMES

If there is a programme setting which you use frequently, the

appliance offers the possibility to save one setting for each

programme so that it can be used again by just pushing one

button.

• Select the desired programme, temperature, spin speed

and option(s), push and hold the “Favourites” button

for at least 3 seconds. The lamp next to “Favourites”

shortly flashes and then lights up - the programme settings

is saved.

Next time you want to use your individual programme

settings, select the programme, push the “Favourites”

button and start by pushing “Start/Pause”.

If you want to replace the saved programme setting by

another one:

• Select programme temperature, spin speed and options as

desired and then press and hold the “Favourites” button

for at least 3 seconds.The previously saved programme

setting will be replaced by the new one.

START DELAY

The “Start delay” button allows the user to run the machine

at his c onvenience, for example at night when electricity is

cheaper.

• Do not use liquid detergent when activating this function.

• Select programme, spin speed and options.

• Press the “Start delay” button several times to select a

delay time by 1 to 24 hours.

• Start the programme (see “Progremme Start”). The

indication lamp over the “Start delay” button lights up and

goes off when the programme starts.

• Once having pressed the “Start/Pause” button, the

countdown of the time delay begins. The time delay

indication on the display disappears when the programme

starts and is replaced by the remaining time.

• After the “Start/Pause” button has been pressed, the

number of hours preselected can be reduced by pressing

again the “Start delay” button.

To cancel the “Start delay”

..before you press the “Start/Pause” button:

• Turn the programme selector to another position or press

the “Reset/Drain” button.

..after having pressed the “Start/Pause” button:

• Press the “Reset/Drain” button for at least 3 second.

The start delay indicator light goes off.

PROGRAMME START

Open the tap and press the “Start/Pause” button. The

indication lamp next to the “Start/Pause” button lights up.

The display shows the remaining programme time. Due

to variations in load and temperature of inlet water, the

remaining time is newly calculated in certain programme

phases. If this is the case, an animation appears on the

time display.

“LID OPEN” INDICATION

Before starting and after end of a programme, the lamp

lights to show the the lid can be opened. As long as a wash

programme is running, the lid remains locked and must on

no account be forced open. In case you have an urgent need

to open it during a running programme, refer to “Cancel a

running programme before the end”.

Programme

Tempe-

rature

(°C)

Load

(kg)

Water

(l)

Energy

without “Rapid”

(kWh)

Approx. Programme Duration

(hrs : min)

Approximete remaining

moisture content (%)***

without “Rapid” with “Rapid” 1000 rpm 1200 rpm

Mixed 40 3.0 45 0.43 1:00 – 68 61

eCotton

** 60 7.0 48 0.90 4:00 –

62 44eCotton

** 60 3.5 34 0.79 2:30 –

eCotton

** 40 3.5 34 0.61 2:30 –

Cotton 95 7.0 58* 2.00 2:35 2:00

62 53Cotton 60 7.0 54 1.20 2:35 1:45

Cotton 40 7.0 64 1.00 3:00 1:30

Synthetics 60 3.0 54* 0.85 1:55 1:14

47 40

Synthetics 40 3.0 50 0.52 1:40 0:59

Delicates 40 1.5 50 0.51 0:45 –

Wool 40 1.0 40 0.55 0:35 –

Colours 40 4.0 59 0.40 1:20 1:00

Speed 30´ 30 3.0 42 0.25 0:30 –

Sport 30 3.0 55 0.40 1:55 1:14

Business 40 1.5 50 0.51 0:45 –

Jeans 40 4.0 48 0.35 1:30 1:10

Aqua Eco 40 2.5 19 0.40 1:00 –

Bauknecht WAT PLATINUM 781 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Andere handleiding(en) van Bauknecht WAT PLATINUM 781

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info