506948
7
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
GB 7
CARE AND MAINTENANCE
Appliance exterior and control panel
Wash down with a soft, damp cloth; if necessary
use a neutral detergent (non abrasive). Dry with
a soft cloth.
Appliance interior
After each washing, leave the door open for some
time to allow the inside of the appliance to dry.
If you never or seldom wash your laundry at
95°C, we recommend to occasionally run a 95°C
programme without laundry, adding a small
amount of detergent, to keep the interior of the
appliance clean.
Door seal
Dry the door seal after each washing with an
absorbent cotton cloth; make sure that the door
seal is completely dry before closing the door of
the empty washing machine.
Check the condition of the door seal periodically.
Filter
Check and clean the filter regularly, at least two
or three times a year (see “Draining Residual
Water/Cleaning The Filter”).
Do not use flammable fluids for cleaning
the appliance.
Cleaning the detergent dispenser
1.
Pull out the dispenser drawer until it stops. Press with your finger
on the space of the siphon being marked with “PUSH” (fig. “
A
”)
to release the drawer and pull it out completely.
2.
Remove the siphon from the softener chamber by pulling it
upwards (fig. “
B
”).
3.
Wash all the parts under running water.
4.
Clean the dispenser compartment with a damp cloth.
5.
Refit the siphon in the softener chamber by pushing it down until
it stops; then push the dispenser drawer back into the dispenser
compartment.
Water supply hose(s) (picture C, D or E - depending on model)
Check regularly for brittleness and cracks. If a supply hose shows a
damage, replace it by a new hose of the same type, available through
our After-Sales Service or your specialist dealer.
If the inlet hose of your washing machine corresponds with the model
on picture “
D
”, periodically check the safety valve inspection window:
if it is red, the hose’s waterstop function was triggered, and the hose
must be exchanged by a new one from our After-Sales Service or your
specialist dealer. For unscrewing the inlet hose as shown on picture
D
”, you must push down the release lever while unscrewing it.
If your supply hose has a transparent hose coating (fig. “
E
”),
periodically check the colour; if it intensifies locally, the hose may
have a leak and should be replaced. Contact our After-Sales Service
team or specialist dealer to obtain a replacement hose.
Cleaning the mesh filter in the water supply hose(s)
1.
Close the tap and loosen the inlet hose on the tap.
2.
Clean the internal mesh filter and screw the water inlet hose back
onto the tap.
3.
Now unscrew the inlet hose on the rear of the washing machine.
4.
Pull off the mesh filter from the washing machine connection
with universal pliers and clean it.
5.
Refit the mesh filter and screw the inlet hose on again.
6.
Turn on the tap and ensure that the connections are completely
water-tight.
B
A
PUSH
D
Safety valve
inspection
window
Release
lever
E
C
30106370GB.fm Page 7 Thursday, January 20, 2011 4:52 PM
Black process 45.0° 130.0 LPI
7

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bauknecht WAK 2570 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bauknecht WAK 2570 in de taal/talen: Engels als bijlage per email.

De handleiding is 5,56 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Bauknecht WAK 2570

Bauknecht WAK 2570 Snelstart handleiding - Nederlands - 2 pagina's

Bauknecht WAK 2570 Gebruiksaanwijzing - Nederlands - 11 pagina's

Bauknecht WAK 2570 Snelstart handleiding - Deutsch - 2 pagina's

Bauknecht WAK 2570 Gebruiksaanwijzing - Deutsch - 11 pagina's

Bauknecht WAK 2570 Snelstart handleiding - English - 2 pagina's

Bauknecht WAK 2570 Gebruiksaanwijzing - Français - 11 pagina's

Bauknecht WAK 2570 Snelstart handleiding - Français - 2 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info