506500
2
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
5019 603 33004
D F NL E P GR
DK
S N FIN
IGB
Freezer compartment temperature adjustment
The appliance is normally factory set to operate at the recommended temperature of -18°C.
To alter the internal temperature between -16°C and -24°C, proceed as follows:
Press button
I/a
or
I/b
once to adjust the internal temperature: the digital display shows the
temperature previously set.
Each time the button is pressed, the temperature setting is changed by 1°C: the value (between
-16°C and -24°C) flashes on the display.
Approximately 5 seconds after the button has been pressed for the last time, the set temperature
is stored, the display stops flashing and the current internal temperature is shown on the display.
Note:
The digital display shows internal temperature values between +10°C and -24°C.
In the event of a power failure, selected functions remain stored in the memory.
Fast freezing
The fast freeze function is automatically deactivated after 48 hours.
Alarm signals
Note:
The temperature alarm may activate if the door is left open for a prolonged period of time or following
the introduction of fresh food in the freezer compartment; this temporary rise in temperature does not
affect the storage of already frozen food in any way.
Defrosting
Control panel lock function
This function prevents anyone inadvertently altering operating parameters or switching the appliance
off. To lock the control panel:
press button J and then button B
and hold down for about 5 seconds,
until the yellow led
G
lights up. To unlock the control panel, press the same buttons again until the
yellow led
G
switches off.
Signal Cause Solution
Door open alarm
The acoustic alarm is
activated
The door has been left open
for more than 1 minute
Close the door
Temperature
alarm
The acoustic alarm and red
led
F
are activated
The internal temperature is
above -12°C
Press button
E
; wait for
the temperature to fall
below -12°C again
Temperature
sensor alarm
The acoustic alarm is
activated and the display
shows
“SF”
Temperature sensor fault Contact After-sales
service
Prolonged power
failure alarm
The acoustic alarm and red
led
F
are activated; the
display flashes, indicating
the highest temperature
reached following the
power failure.
Prolonged lack of power
supply, causing the internal
temperature to rise to very
high values at which correct
food storage cannot be
guaranteed
Press button
E
; the
display now indicates
the current internal
temperture.
1.
Press the freezer on/off button
B
An illuminated dot appears on the digital
display
2.
Unplug the appliance or switch off at the
main switch
3.
Follow the instructions given in the
instructions booklet
4.
Plug in the appliance once again
5.
Press the freezer on/off button
B
. Follow the steps detailed in “Switching on the
appliance”
6Gb33004.fm5 Page 2 Thursday, January 25, 2001 4:32 PM
2

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Bauknecht-GKEA-245-Optima

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bauknecht GKEA 245 Optima bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bauknecht GKEA 245 Optima in de taal/talen: Engels als bijlage per email.

De handleiding is 0,07 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Bauknecht GKEA 245 Optima

Bauknecht GKEA 245 Optima Gebruiksaanwijzing - Nederlands - 8 pagina's

Bauknecht GKEA 245 Optima Snelstart handleiding - Nederlands - 2 pagina's

Bauknecht GKEA 245 Optima Gebruiksaanwijzing - Deutsch - 8 pagina's

Bauknecht GKEA 245 Optima Snelstart handleiding - Deutsch - 2 pagina's

Bauknecht GKEA 245 Optima Gebruiksaanwijzing - English - 9 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info