PPS (Phantom Power Supply)
Power supply socket for audison
external audio accessories.
2
IN B/OUT
Left (L) and right (R) inputs of the amplifier B channels or amplifier HI/BYPASS preamplified
outputs (see “Configurations table”). Connect only the right (R) channel input in order to use the
amplifier in mono.
4
IN A
Left (L) and right (R) inputs of the amplifier A channels. The preamplified outputs
(PRE OUT) of a source (head unit, CD player, DAT, etc.) or of an external electronic
crossover must be connected to them.
Connect only the right (R) channel input in order to use the amplifier in mono.
3
1
CH A/HI-PASS, CH B/LO-PASS
Power outputs of the amplifier left and right channels.
Connect the speakers cables to these outputs according
to polarity. Terminal blocks accept cables up to 9 A.W.G.
max (see “audison cable products for electronic
connections” as far as their size is concerned). We
recommend the use of audison cable products.
Please use +L and –R terminal blocks called mono in
order to connect every channels pair in bridge and
exploit the maximum power insured by this
configuration.
4
2
1
1
3
2 - Remove the plate without damaging the
silkscreen printed panel which will have to
stay on. We suggest that you seize both plate
grips with your hands and pull them by
blocking the silkscreen printed panel with
your fingers against the amplifier chassis at
the same time. This will permit to remove the
plate from the panel without damages.
3 - Remove the strip with
audison logo.
5 - Mount the plate
back by fixing it
through the screws;
then, re-assemble the
transparent cover
which protects
controls.
4 - Put the strip back again after turning it, so
that audison logo is upside down.
