702279
3
Verklein
Vergroot
Pagina terug
1/32
Pagina verder
P/N 1070346 • REV 5.0 • ISS 03OCT11 3 / 32
EN: Installation Sheet
Introduction
The ATS1235 Advanced Wireless DGP on 868 MHz AM
expands the ATS control panel’s inputs using the Learn Mode
868 MHz AM Wireless Transmitter Sensors (crystal or SAW).
The ATS1235 supports maximal 32 sensors and 16 FOBs.
Advisor Advanced: ATS1235 expands the panel with
16 zones, the DGP option 32 zones is not applicable.
Up to 7 ATS1235 can be connected to the panel.
Advisor Master: ATS1235 expands the panel with 16 or 32
zones depending on the selected DGP mode. Up to 15
ATS1235 can be connected to the panel, depending on
the maximal zone capacity of the panel.
The ATS1235 requires the following control panel firmware
versions:
Advisor Master: ATS1235 requires Advisor Master control
panel firmware version V04.09.16 or later.
Advisor Advanced: ATS1235 requires Advisor Advanced
control panel firmware version MR_017.017.0067 or later.
The maximum recommended data bus length is 1500 m when
one or more ATS1235 wireless DGPs are connected.
The wireless DGP features spatial diversity to minimise
wireless signal nulls or dead spots. If dead spots need to be
eliminated, an 868 MHz AM repeater can be used.
The wireless DGP can be powered from the ATS control panel
data bus or from a remote auxiliary power supply.
Fob buttons can be programmed to arm and disarm areas, or
to control relays. For example, relays could be used to open
and close a garage door remotely.
ATS1235 PCBs layout
Figure 1 legend
Item Description
(1) Interface board.
(2) Radio board.
(3) External tamper connection.
Place jumper when mounted in plastic ATS control panel
housing.
Do not place jumper when mounted in ATS1235 housing.
(4) USB connection (mini B-type). Used to upgrade the
firmware.
(5) Bus 470 EOL.
(6) ATS bus.
(7) CON3 and CON1 - connectors to radio board.
(8) Flash jumper.
Put jumper in Flash position (bottom pins) to allow the
firmware upgrade.
(9) DIP switches.
(10) Tamper switch.
Basic system description
The ATS control panel collects the data from the wireless DGP
on the data bus. The ATS1235 can be powered by the control
panel, or by a remote, 220 V powered DGP.
The ATS1235 receives the RF signal from the wireless
devices, such as fobs, PIR sensors, or smoke detectors.
A programmable supervision function monitors the state of the
devices in the field. Transmitters send one supervisory signal
every 18 minutes. Smoke sensors send one supervision signal
every 63 minutes. For more details of the supervision
functionality, refer to menus 8, 9, and 10.
Mounting location
The ATS1235 can be mounted on any interior wall.
Notes
Avoid areas where the wireless DGP may be exposed to
moisture.
Avoid excessive metal or electrical wiring, for example,
furnace and utility rooms.
If mounting the wireless DGP near metal, give the antenna
as much clearance as possible. See Figure 3.
Installing the unit
Figure 2 legend
Item Description
(1) Housing base
(2) Mounting holes
(3) Cable entry
Mounting the ATS1235
1. Remove power from the ATS control panel before
installation.
2. Remove the ATS1235 plastic cover.
3. Hold the base of the ATS1235 against the mounting
surface and mark the two mounting holes.
4. Drill holes and insert screw anchors, if required.
5. Secure the unit to the mounting surface with the screws
provided. If mounted near metal, give the antenna as
much clearance as possible.
Connecting the ATS1235 (see Figure 1)
1. Connect the four bus cable wires to the terminal strip
CONN10 on the DGP.
+12 to +12V
GND to 0V
D+ to D+
• D to D
2. Connect the bus cable to the ATS control panel bus.
Connect the power cable to the control panel auxiliary
power, or run a separate power cable to the nearest mains
powered DGP. When using a remote DGP power supply,
0 V must be connected to the panel and the DGP as well.
3

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Aritech ATS1235 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Aritech ATS1235 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans als bijlage per email.

De handleiding is 0,4 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info