47615
11
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
Troubleshooting
Problem:
The machine won’t start?
The wash cycle won’t
start?
The machine fails to fill
with water?
The machine continuously
fills with water and drains?
The machine does not
drain or spin?
The machine vibrates too
much during the spin
cycle?
The machine leaks?
There is too much foam?
The ON-OFF/DOOR
LOCKED LED flashes
rapidly at the same time as
at least one other LED?
Possible causes / Solution:
The appliance is not fully plugged into the socket.
There has been a power failure.
The appliance door is not shut properly.
The button has not been pressed, for at least 2 seconds.
The START/RESET button has not been pressed, for at least 2 seconds.
The water tap is not turned on.
A delayed start has been set (using the Delay Timer, see Personalisation).
The water inlet hose is not connected to the tap.
The hose is kinked.
The water tap is not turned on.
There is a water shortage.
The water pressure is insufficient.
The START/RESET button has not been pressed, for at least 2 seconds.
The drain hose is not fitted between 65 and 100cm from the floor (see Installation).
The free end of the hose is underwater (see Installation).
The wall drainage system doesn’t have a breather pipe.
If the problem persists even after these checks, turn off the water tap, switch
the appliance off and call for assistance. If the dwelling is on one of the upper
floors of a building, there may be drain trap problems causing the washing
machine to load and unload water continuously. In order to avoid such an
inconvenience, special anti-drain trap valves are available in shops.
If the machine was unable to balance the load it will use a slow spin rather
than risk machine damage; the clothes might appear wetter than expected.
The Easy Iron option is enabled: to complete the programme, press the
START/RESET button (see Personalisation).
The drain hose is bent (see Installation).
The drain duct is clogged.
Your machine is fitted with a filter system for the pump - This filter may have
become blocked (see Care and Maintenance for details of how to remove
any blockage from the pump filter).
Has the SPIN SPEED knob been set to ‘No Spin’ ? (see Personalisation).
The transit bolts were not removed correctly (see Installation).
The washing machine is not level (see Installation).
The washing machine is closed in, between furniture cabinets and the
wall (see Installation).
The water inlet hose is not screwed on correctly (see installation).
The detergent dispenser is obstructed (to clean it, see Detergent and Laundry).
The drain hose is not secured properly (see Installation).
The detergent is not suitable for machine washing (it should bear the
definition “for washing machines” or “hand and machine wash”, etc).
You used too much detergent.
Call for assistance because this means there is an error.
One day your machine seems not to be working. Before you call your Service Centre (see Service), go through the
following troubleshooting suggestions:
11
GB
11

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Ariston A1637 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Ariston A1637 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,55 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info