665483
28
Verklein
Vergroot
Pagina terug
1/30
Pagina verder
EG
28
Temperature delta setting for restart of the heat pump
When the water temperature reaches the set value or the maximum achievable value (in the case of Emix operation with-
out other indoor units), the heat pump switches off and starts up again only when the water temperature drops below the
desired temperature of a certain value (delta).
You can change the startup delta of the heat pump by setting it to 5°C or 10°C.
To change the set value, from the conguration menu, quickly press BUTTON 9 until the BLUE and RED LEDs are ash-
ing.
Then wait a few seconds until all the 5 GREEN LEDs light up and press BUTTON 9 once more.
3 consecutive beeps conrm the setting.
NOTE
By default the startup delta of the heat pump is set to 10°C.
Reset of the factory settings
To reset all the factory settings, from the conguration menu, quickly press BUTTON 9 until the BLUE, YELLOW and RED
LEDs are ashing.
Then wait a few seconds until all the 5 GREEN LEDs light up and press BUTTON 9 once more.
3 consecutive beeps conrm the reset of factory settings.
In addition to the already described modes in the section “EMIX CONFIGURATION”, Emix software can automatically
manage electrical back up heaters under certain conditions. This mean that these operation modes are not to be set and
that can not be deactivated. They are:
- Antifreeze mode
- Cold draft prevention mode
- Electrical water heater mode (in case heat pump is not active)
- Antilegionella cycle
Electrical back up heater management – Antifreeze mode
If water temperature inside the tank is lower than 5° C, all connected electrical elements are switched on until the water
temperature reaches 10° C.
Electrical back up heater management – Cold draft prevention mode
When one or more indoor units are in cold draft prevention mode and compressor is operating since 20’, one by one
electrical element are switched on every 20’; they will be switched off one by one when no indoor unit will be any more
in Cold draft prevention mode.
Electrical back up heater management – Electric water heater mode
If the outdoor unit is stopped for maintenance the end user could decide to use Emix as controller of the electrical heater
elements located inside the tank, exactly like any electrical water heater. In this case, if the water temperature is lower
than the desired temperature for more than 10’, all the connected electrical heaters will switch on up to the reaching of
the setpoint. End users can switch off Emix if they do not want to utilise this option.
Electrical back up heater management – Antilegionella cycle
During the Antilegionella cycle, one or more electrical heaters may be automatically switched on. See section “ANTILE-
GIONELLA CYCLE”.
OPERATION OF THE ELECTRICAL HEATER ELEMENTS
28

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Argo Emix Tank bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Argo Emix Tank in de taal/talen: Duits, Engels, Frans, Italiaans, Portugees, Spaans, Zweeds, Fins als bijlage per email.

De handleiding is 4,64 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Argo Emix Tank

Argo Emix Tank Gebruiksaanwijzing - Deutsch - 29 pagina's

Argo Emix Tank Gebruiksaanwijzing - English - 29 pagina's

Argo Emix Tank Gebruiksaanwijzing - Français - 29 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info