541773
6
Verklein
Vergroot
Pagina terug
1/9
Pagina verder
5
The Rear Panel
SVT-8 PRO Bass Amplifier
20. AC LINE IN: Firmly insert the supplied AC
power cord into this socket until it is fully seat-
ed. Plug the male end of the cord into a
grounded AC outlet. DO NOT DEFEAT THE
GROUND PRONG OF THE AC PLUG!
21. BAL. OUT: This jack supplies a line level
signal for connection to a house mixing board,
recording console or external amplifier. The sig-
nal level at this jack is governed by the Post/Pre
switch (#23).
22. GND/LIFT: Use this switch to lift the ground
connection at the Bal. Out jack to help eliminate
hum in the Bal. Out signal.
23. POST/PRE: The signal at the Bal. Out jack
(#21) can be set to either Pre or Post-EQ with
this switch. With the swi
tch in the OUT position,
the signal at the jacks is Pre-EQ. This is a direct
output not affected by any EQ or boost settings.
With the switch depressed, the signal is Post-
EQ and is controlled and modified by the tone
controls and the effects loop.
24: TUNER OUT: This jack is provided for con-
nection to an electronic tuner and is always
“live, even when the Mute switch (#3) is
engaged. This allows for “silent tuning as well
as a monitor feed which stays hot even when
the house mix is muted.
25. SPEAKERS: These output jacks supply
speaker-level power to the speaker cabinet.
The rated power output is 1300 watts rms
into 4 ohms or 2500 watts rms into 2 ohms
(minimum load).
WARNING: Use speaker cables to make
the connections. Do not use instrument
cables as they may overheat.
Pin 1+ = hot
Pin 1– = return
26. CIRCUIT BREAKER: The SVT-8 PRO
employs an AC line circuit breaker to
help pro-
tect against damages due to excessive current
demands. If the amplifier stops working, check
the circuit breaker.
27: POWER AMP IN: This jack connects an
external preamp directly to the power amp.
When using an external source, connect the
output of the source to this jack by means of a
shielded signal cable to feed the signal into the
power amp section. The internal signal is dis-
connected when a connector is inserted into
this jack.
28. PREAMP OUT: Use this jack to send a sig-
nal from the internal preamp to an auxiliary
power amplifier, mixing console, monitor sys-
tem, or
house PA system. The signal at this
jack is post-EQ.
29. EFFECTS LOOP RETURN: When using
an external signal processor, connect the out-
put of the device to this jack by means of a
shielded signal cable.
30. EFFECTS LOOP SEND: When using an
external signal processor, connect this jack to
the input of the device by means of a shielded
signal cable.
31. FOOTSWITCH: Connect a two-button
(ring/tip/sleeve) footswitch to this jack to control
the Power Reduction and the Mute functions.
(Mute = tip/sleeve; Power Reduction = ring/
sleeve.)
NOTE: A footswitch may be purchased at
your local Ampeg Dealer or ordered directly from
LOUD Technologies Inc. Be sure to ask for
model #AFP2.
IMPORTANT: This unit employs forced air
cooling by means of an internal fan. The
rear and side ventillation slots must remain
unobstructed when operating this amplifier.
When mounting the unit in a rack make sure
there is ample room for proper air circulation.
The rack must be constructed and positioned
in such a manner to allow proper air flow and
the exhausting of hot air away from the rack
at all times.
WA R NING :
Made In T he U.S .A .
L OUD T E CH NOL OG IE S, INC .
10240V 50/60Hz 300VA
250 0W @ 2 O HMS
130 0W @ 4 O HMS
C LA SS 2 W IR ING
T his device c ompli es with pa rt 15 of th e F CC R ule s.
Op erati on is su bjec t to the follow ing two c ond ition s:
this devic e m ay not c au se ha rmfu l in terferenc e, and this
dev ice mu st acc ept any in terfe renc e r ec eive d, i nclu ding
inte rfer enc e th at m ay ca us e u ndes ir ed o pera tion .
26 27 28 3129 30
20 2421 2522 23
26 27 28 3129 30
20 2421 2522 23
W
6

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Ampeg SVT-8 Pro bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Ampeg SVT-8 Pro in de taal/talen: Engels als bijlage per email.

De handleiding is 1,72 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info