471389
35
Verklein
Vergroot
Pagina terug
1/37
Pagina verder
33-EN
Full Speed Connector
Control iPhone/iPod signals.
Connect this to an iPhone/iPod by using FULL SPEED Connection
Cable (KCE-433iV) (sold separately for CDE-111R/CDE-111RM/
CDE-113BT) or to an external device (such as a portable player) by
using conversion cable (KCE-237B) for building up the AUX IN (sold
separately).
Note
Refer to “Setting the AUX+ SETUP Mode” on page 19.
AUX+ ON :
When the external device is connected.
AUX+ OFF :
When an iPhone/iPod is connected.
You can also connect this to an optional BLUETOOTH INTERFACE
(KCE-400BT) (CDE-111R/CDE-111RM/CDE-112Ri only). To use a
hands-free mobile phone, an optional BLUETOOTH INTERFACE
(KCE-400BT) connection is required. For details on connection, refer
to the Owners Manual of the BLUETOOTH INTERFACE (KCE-400BT).
Antenna Receptacle
Audio Interrupt In Lead (Pink/Black)
Connect this lead to the Audio Interface output of a cellular phone
which provides ground shorting when a call is received.
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your amplifier or
signal processor.
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s fuse box or
another unused power source which provides (+) 12V only when the
ignition is turned on or in the accessory position.
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle. Make sure
the connection is made to bare metal and is securely fastened using
the sheet metal screw provided.
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna, if
applicable.
Note
This lead should be used only for controlling the vehicles power
antenna. Do not use this lead to turn on an amplifier or a signal
processor, etc.
Dimmer Lead (Orange) (CDE-112Ri/CDE-113BT/ CDE-114BTi
only)
This lead may be connected to the vehicle’s instrument cluster
illumination lead. This will enable the vehicles dimmer control to dim
the backlighting of the unit.
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle’s battery.
ISO Power Supply Connector
ISO Connector (Speaker Output)
Left Rear (+) Speaker Output Lead (Green)
Left Rear (−) Speaker Output Lead (Green/Black)
Left Front (+) Speaker Output Lead (White)
Left Front (−) Speaker Output Lead (White/Black)
Right Front (−) Speaker Output Lead (Grey/Black)
Right Front (+) Speaker Output Lead (Grey)
Right Rear (−) Speaker Output Lead (Violet/Black)
Right Rear (+) Speaker Output Lead (Violet)
Steering Remote Control Interface Connector
To steering remote control interface box.
You can operate this unit from the vehicle’s control unit when an
Alpine Steering Remote Control Interface Box (optional) is
connected. For details, contact your Alpine dealer.
MIC Input Connector (CDE-113BT/CDE-114BTi only)
To M icrophone.
Fuse Holder (10A)
Front Output RCA Connectors (CDE-112Ri/CDE-113BT/
CDE-114BTi only)
RED is right and WHITE is left.
Rear/Subwoofer Output RCA Connectors (CDE-112Ri/
CDE-113BT/CDE-114BTi only)
Front/Subwoofer Output RCA Connectors (CDE-111R/CDE-111RM
only)
RED is right and WHITE is left.
Power Supply Connector
RCA Extension Cable (sold separately)
FULL SPEED Connection Cable (KCE-433iV) (sold separately
for CDE-111R/CDE-111RM/CDE-113BT)
KCE-400BT Connection Cable (Included with KCE-400BT)
ISO/JASO Antenna Adaptor (sold separately)
An ISO/JASO antenna adapter may be required, depending on the
vehicle.
Front AUX Input Terminal (CDE-112Ri/CDE-113BT/
CDE-114BTi only)
This terminal allows for input of audio from an external device (such
as a portable player), using a commercially-available converter cable.
USB Terminal
Connect this to a USB Memory (sold separately).
To prevent external noise from entering the audio system.
Locate the unit and route the leads at least 10 cm away from the
car harness.
Keep the battery power leads as far away from other leads as
possible.
Connect the ground lead securely to a bare metal spot (remove
any paint, dirt or grease if necessary) of the car chassis.
If you add an optional noise suppressor, connect it as far away
from the unit as possible. Your Alpine dealer carries various
noise suppressors, contact them for further information.
Your Alpine dealer knows best about noise prevention
measures so consult your dealer for further information.
35

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Alpine-CDE-114BTi

Zoeken resetten

  • Als ik een cd wil plaatsen gaat het toestel knipperen, en doet dus niks.
    Moet hij dan gereset worden ? en zo ja, hoe doe ik dat ? Gesteld op 26-11-2013 om 10:20

    Reageer op deze vraag Misbruik melden
    • De reset knop bevind zich onder het "frontje". Het is een klein knopje, links schuin onder de CD lade. Indrukken met een puntig voorwerp , bv een balpen.

      Sukses Fred Geantwoord op 1-12-2013 om 08:39

      Waardeer dit antwoord Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Alpine CDE-114BTi bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Alpine CDE-114BTi in de taal/talen: Engels als bijlage per email.

De handleiding is 2,96 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Alpine CDE-114BTi

Alpine CDE-114BTi Gebruiksaanwijzing - Nederlands - 40 pagina's

Alpine CDE-114BTi Gebruiksaanwijzing - Deutsch - 41 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info