ENGLISH
- 3 -
Dear Customer,
Thank you for choosing Alpina home appliance. You have chosen the best appliances that offer
2 years/24months warranty and years of service. We stand for quality, dependability and
friendship forever. We hope you will choose Alpina again and make ALPINA your first choice in
home appliances.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be
followed, including the following:
1. Read all instructions carefully.
2. This appliance may only be connected to the same main voltage as shown on the rating
plate.
3. To protect against risk of electrical shock, do not immerse or rinse housing, cord or plug in
water or other liquid.
4. Close supervision is necessary when any appliance is used near children.
5. Unplug from outlet when not in use, before putting on or taking off parts and before
cleaning.
6. Do not contact any moving parts while the appliance is operating.
7. If the supply cord is damaged, it must be replaced by the manufacturer or its authorized
service agent or a similarly qualified person in order to avoid hazard & damage to the unit.
8. The use of attachment or accessories which are not supplied with the appliance are not
recommended. This could result in electrical shock or injury or permanent damage to the
appliance.
9. Do not let cord hang over edge of table or counter or touch hot surface.
10. Do not use the appliance for other than intended household use.
11. Switch off the appliance before changing accessories or approaching parts, which move in
use.
12. The appliance is not intended for use by young children or infirm persons without
supervision. Young children should be supervised to ensure that they do not play with the
appliance.
13. Do not obstruct the air flow.
14. Do not operate the fan without the guard.
This appliance is for household use and may be plugged into any AC electrical outlet (ordinary
household current). Do not use any other electrical outlet.
HOW TO ASSEMBLE:
1. Slide the 2-off base cross sections together.
2. Remove the screws from the centre of the base cross section, and then fasten the fan
pole in position.
3. Unscrew and remove the plastic retainer that locks the two pole sections together, slide
over and fit the plastic base cover.
4. Set the height of the chrome extension pole and then lock into position with the plastic
screwed retainer.
5. Slide the motor and switch control section over the chrome extension pole and secure
into position.
6. Unscrew guard retaining nut anti-clockwise and remove.
7. Take the rear guard section and slide it over the threaded screw on the fan body (make
sure the handle on the guard is facing upwards)
8. Screw on the guard retaining nut to secure the rear guard in place.
9. Push the blade on to the motor shaft until it reaches the stop.
10. Screw on the blade retaining cap in an anti-clockwise direction to secure the blade in
position.
11. Hook the front guard on to the rear guard section at the top.
12. Secure the two guard sections together with the clips around the edges. The screw and
nut at the bottom of the grille must be fitted.
