693708
4
Verklein
Vergroot
Pagina terug
1/24
Pagina verder
4
FRONT PANEL
1. Trim – Sets the channel’s input level. Adjust this so that the Peak LED lights on the
loudest passages and then back it down so it no longer peaks.
2. Peak LED – The LED will flash if the signal is clipping. If this happens, decrease the
setting of the Gain knob or Channel fader.
Note: Avoid amplifier “clipping” at all costs. Clipping occurs when the power
amplifier is distorting and working beyond its limits. Amplifier distortion is THE
major cause of speaker failure.
3. Hi EQ – Provides up to 15dB of boost or cut to the 12 KHz frequency range.
4. Lo EQ – Provides up to 15dB of boost or cut to the 80 Hz frequency range.
5. Aux 1 – Sends the channel’s signal to auxiliary processors, onstage monitors, or
headphone amplifiers.
Aux 1 is pre-fader, meaning it takes the signal before the channel fader position. Aux
1 is ideal for sending a signal to monitors or headphone amplifiers.
6. Aux 2 – Sends the channel’s signal to auxiliary processors, onstage monitors, or
headphone amplifiers. Aux 2 is post-fader, meaning it takes the signal after the
channel fader position. Aux 2 is ideal for sending a signal to outboard processors.
7. Channel Fader – Controls the signal level of the Mic
and Line inputs.
8. Pan/Bal (Balance) – Directs the output signal to the left
or right Main Out. Pan controls are found on mono
channels, sending the mono source to either the left or
the right speakers or anywhere in between.
The Balance
controls are found on stereo channels which take a
stereo source and varies the relative level of the
channels, so that the left channel will not come out of
the right speaker when adjusting the Balance control
fully right and vice-versa.
9. Ext In – 1/8" stereo line level input for channels 9 and
10.
10. Ext Out – 1/8" stereo output that mirrors the main
outputs.
11. Mic Input 1/2 – XLR-1/4” combo inputs for use with
dynamic and condenser mics. The signal level is
controlled with channel faders 1 and 2, respectively.
When front panel Mic inputs 1 and 2 are in use, this will
disable the rear panel Mic 1 and 2 inputs.
12. Power LED – Indicates whether MultiMix 10 Wireless is
powered on or off.
13. Phantom Power LED – Indicates whether the phantom
power is enabled for the Mic inputs.
14. Pair/Unpair – Press the Pair/Unpair button to pair a Bluetooth® device or to disconnect a paired Bluetooth
device.
15. Pair LED – The Pair Status LED will illuminate when MultiMix 10 Wireless is paired with a Bluetooth audio
device.
16. LED Meters – Displays the audio signal level of the main outputs.
17. Master Fader – Adjusts the speaker’s Main Out volume, which includes the Mic/Line inputs, Ext. In, and the
audio of a paired Bluetooth device.
18. Stereo Aux Return – Controls the signal level returning from the Aux inputs.
19. Phones/Monitor Knob – Adjusts the signal level sent to the Monitor Out and the Phones Output.
20. Phones Output – Connect headphones to this stereo 1/4” output.
Note: To avoid interruptions during playback,
we recommend putting your Bluetooth device
in Airplane Mode and deactivating any alarms
or alerts before activating Bluetooth.
12
13
14
10
11
16
17
18
19
20
15
11
9
1
3
4
5
6
2
7
8
12
12
13
13
14
14
10
10
11
11
16
16
17
17
18
18
19
19
20
20
15
15
11
11
9
Wireless
1
3
4
5
6
2
7
8
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such
marks by Alesis is under license. Other trademarks and trade names are those of their respective owners.
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Alesis MultiMix 10 Wireless bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Alesis MultiMix 10 Wireless in de taal/talen: Duits, Engels, Frans, Italiaans, Spaans als bijlage per email.

De handleiding is 3,42 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info