794954
5
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
USER MANUAL INTRODUCTION
The Alecto FR-115 is a PMR-446 walkie-talkie.
This walkie-talkie allows you to not only commu-
nicate with each other free of charge, but also
with other (Alecto) walkie-talkies provided they
meet the PMR-446 standard.
DISPLAY FUNCTIONS
VOX = Voice Controlled Transmitting
SCAN = Channel Scan
Channel number
CTCSS subcode
= Standby
Battery level = receiving
= Sending
Key lock
Set volume level
FUNCTIONS INSTALLATION
POWER:
The FR-115 is powered through 3x AAA penlite
batteries.
1. Open the battery compartment by pressing
the tab at the bottom of the battery cover
upwards, the battery cover can then be
removed.
In order to avoid the risk of
suffocation when used by small
children, because the belt clip is
a relatively small part, the belt clip
has been glued by the factory.
Removal and re-installation of the
battery cover may be more difficult.
2. Install the batteries according
to the markings in the battery
compartment and close the
battery compartment.
HEADSET:
On top of the FR-115 you’ll find the connector
for a headset with a 2.5mm plug. We advise you
to use an Alecto FRH-10 headset for this.
USE
Attention: for a connections between 2
walkie-talkies, both walkie-talkies must
be set to the same channel, with the same sub-
code. See further on in this manual how to set
the channel and sub-codes.
TO SWITCH ON/OFF:
Press and hold the button for 2 seconds to
switch the walkie-talkie on or off.
VOLUME CONTROL:
Repeatedly and briefly press the or button
to adjust the volume. The set volume level is
shown in the lower part of the display.
TO SEND:
Press the P button to send. Keep this button
depressed while speaking. Talk at a normal
voice volume and approximately 3 to 5 cm from
the walkie-talkie’s microphone.
TO RECEIVE:
Release the P button to receive.
CALL ALERT TONE:
Press the P button briefly to transmit a call alert
tone. This call alert tone is adjustable, see ‘To
change the call alert tone’ further on in this
manual.
BACKGROUND LIGHTING:
Each time you press a function button (except
the flash light button) the background lighting of
the display will illuminate. This lighting will auto-
matically switch off 10 seconds after pressing
the last button
FLASH LIGHT:
Use the button to switch on the built-in flash
light. This light remains lit for as long as you
keep this button depressed.
The walkie-talkie doesn’t need to be switched
on to use this function.
Attention: Don’t stare directly into the light when
lit and don’t shine it in other people’s eyes.
The light can be bright and may damage your
eyesight.
ADDITIONAL FUNCTIONS
VOX FUNCTION:
When the VOX function is enabled (VOX =
Voice Activated Transmission), the FR-115 starts
sending as soon as you speak into the micro-
phone.
To switch the VOX function on/off:
1. press 3x the MENU button, the word “VOX”
will illuminate in the left part of the display
2. use the buttons or to set the trigger sen-
sitivity (‘OF’ is off, ‘1’ is the lowest sensitivity,
‘3’ is the highest sensitivity)
3. press the P button to confirm
Preferably, use this function in combination with
headsets. Keep in mind that it can take over a
second after you’ve started talking before the
walkie-talkie enables the transmitter.
CHANNEL MONITORING: (listening)
Use this function to disable the noise reduction,
allowing you to also listen to weak transmitters
on the current channel.
To switch the MONITOR function on/off:
1. press and hold the button for 2 seconds to
disable the noise reduction and to monitor the
channel
2. release the button to turn the noise reduc-
tion on again
CHANNEL SCAN:
Use the scan function to listen in on all channels
one after the other.
1. Press and hold the button for 2 seconds to
start the scan
2. briefly press the or button to continue
scanning if you’re only receiving noise on a
certain channel
3. press the P or MENU button to end the scan
KEYPAD LOCK:
When the keypad lock is activated, the , and
MENU buttons are blocked.
1. press and hold the MENU button until
appears in the display after approx. 2 sec-
onds
2. press and hold the MENU button again for
2 seconds to release these buttons again
SETTINGS
TO CHANGE THE SEND/RECEIVE
CHANNEL:
1. press 1x the MENU button and the channel
indication starts flashing
2. press the or button to select the desired
channel
3. press the P button to confirm
TO CHANGE THE SUB-CHANNEL (CTCSS):
1. press 2x the MENU button and the sub-chan-
nel indication starts flashing
2. use the or button to set the desired
sub-channel (1-38) or disable this function by
selecting OF
3. press the P button to confirm
Keep in mind that the walkie-talkie at the receiv-
ing end must be set to the same sub-channel.
Sub-channel explanation, (CTCSS code):
Continuous Tone Controlled Squelch System
is a tone code that’s included while transmit-
ting. This tone code is not audible. Only when
the tone code of the transmitting walkie-talkie
matches the tone code of the receiving walkie-
talkie, the receiving walkie-talkie will reproduce
the signal. This prevents you from being dis-
turbed by other PMR-446 walkie-talkies commu-
nicating on the same channel.
SCAN
VOX
Microphone
Flash light
Headset output
Antenna
Display
P button
(send button)
Charging contacts
(rear)
Speaker
SCAN
VOX
HI
LO
MENU
1.5V AAA
1.5V AAA
1.5V AAA
FR-115
FR115
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Alecto FR115 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Alecto FR115 in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 3.63 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info