707356
1
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
USER MANUAL
INTRODUCTION
The Alecto FR-175 is a PMR-446 walkie-talkie.
This walkie-talkie allows you to not only commu-
nicate with each other free of charge, but also
with other (Alecto) walkie-talkies provided they
meet the PMR-446 standard.
Hereby, Hesdo declares that the radio equip-
ment type Alecto FR-175 is in compliance with
directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the
following internet address:
http://DOC.hesdo.com/FR-175-DOC.pdf
DISPLAY FUNCTIONS
VOX = Voice Controlled Transmitting
SCAN = Channel Scan
Channel number
CTCSS subcode
= Standby
Battery level = receiving
= Sending
Key lock
Set volume level
FUNCTIONS INSTALLATION
POWER:
The FR-175 is powered through the included
rechargeable NiMH battery pack, size 3x AAA,
voltage 3.6V or through the 3x AAA penlite bat-
teries (excl.). If you choose to insert individual
rechargeable batteries, you must charge them
in a separate charger. The charging station sup-
plied with the FR-175 is only suitable for charg-
ing the included battery packs.
1. First remove the belt clip by pressing the
retaining clip backwards
and then press the belt clip
upwards out of the walkie-
talkie.
2. Now open the battery
compartment by pressing
the tab at the bottom of the
battery cover upwards, the
battery cover can then be
removed.
3. Insert the battery pack (the
charging contacts must
remain visible and the “UP”
arrow must point to the top
of the walkie-talkie.
4. Close the battery compartment, make sure
it’s closed properly and slide the belt clip
back onto the walkie-talkie.
The battery pack is provided with a small
strap to easily remove it. Make sure that
this strap, when replacing the rear cover, does
not cover one of the charging contacts at the rear
of the battery pack. Confirm this by placing the
walkie-talkie into the charger, the charging indica-
tor must then illuminate. Also see below.
CHARGING:
Insert the thin low-voltage plug into the side of the
charging station and plug the adapter into a 230V
50Hz wall socket. Place the walkie-talkies into the
charging station to recharge the batteries.
The indicators on the charger will illuminate
to indicate that the battery packs are being
recharged. These indicators remain lit, also when
the battery packs are fully charged. There’s no
risk of overcharging because the charging current
is electronically limited.
You may leave the walkie-talkies enabled while
charging them.
NORMAL BATTERIES:
Insert normal or rechargeable individual
batteries according to the drawing inside
the battery compartment.
When using normal batteries,
you may still place the
walkie-talkies into the charger.
However, the charging indica-
tors won’t illuminate and the
batteries will not be recharged.
When using rechargeable batteries, you must
recharge them in an external charger.
HEADSET:
On top of the FR-175 you’ll find the connector
for a headset with a 2.5mm plug. We advise you
to use an Alecto FRH-10 headset for this.
USE
Attention: for a connections between 2
walkie-talkies, both walkie-talkies must
be set to the same channel, with the same sub-
code. See further on in this manual how to set
the channel and sub-codes.
TO SWITCH ON/OFF:
Press and hold the button for 2 seconds to
switch the walkie-talkie on or off.
VOLUME CONTROL:
Repeatedly and briefly press the or button
to adjust the volume. The set volume level is
shown in the lower part of the display.
TO SEND:
Press the P button to send. Keep this button
depressed while speaking. Talk at a normal
voice volume and approximately 3 to 5 cm from
the walkie-talkie’s microphone.
TO RECEIVE:
Release the P button to receive.
CALL ALERT TONE:
Press the P button briefly to transmit a call alert
tone. This call alert tone is adjustable, see ‘To
change the call alert tone’ further on in this
manual.
BACKGROUND LIGHTING:
Each time you press a function button (except
the flash light button) the background lighting of
the display will illuminate. This lighting will auto-
matically switch off 10 seconds after pressing
the last button
FLASH LIGHT:
Use the button to switch on the built-in flash
light. This light remains lit for as long as you
keep this button depressed.
The walkie-talkie doesn’t need to be switched
on to use this function.
Attention: Don’t stare directly into the light when
lit and don’t shine it in other people’s eyes.
The light can be bright and may damage your
eyesight.
ADDITIONAL FUNCTIONS
VOX FUNCTION:
When the VOX function is enabled (VOX =
Voice Activated Transmission), the FR-175
starts sending as soon as you speak into the
microphone.
To switch the VOX function on/off:
1. press 3x the MENU button, the word “VOX”
will illuminate in the left part of the display
2. use the buttons or to set the trigger sen-
sitivity (‘OF’ is off, ‘1’ is the lowest sensitivity,
‘3’ is the highest sensitivity)
3. press the P button to confirm
Preferably, use this function in combination with
headsets. Keep in mind that it can take over a
second after you’ve started talking before the
walkie-talkie enables the transmitter.
CHANNEL MONITORING: (listening)
Use this function to disable the noise reduction,
allowing you to also listen to weak transmitters
on the current channel.
To switch the MONITOR function on/off:
1. press and hold the button for 2 seconds to
disable the noise reduction and to monitor the
channel
2. release the button to turn the noise reduc-
tion on again
CHANNEL SCAN:
Use the scan function to listen in on all channels
one after the other.
1. Press and hold the button for 2 seconds to
start the scan
2. briefly press the or button to continue
scanning if you’re only receiving noise on a
certain channel
3. press the P or MENU button to end the scan
KEYPAD LOCK:
When the keypad lock is activated, the , and
MENU buttons are blocked.
1. press and hold the MENU button until
appears in the display after approx. 2 sec-
onds
2. press and hold the MENU button again for
2 seconds to release these buttons again
FR-175
SCAN
VOX
Microphone
Flash light
Headset output
Antenna
Display
P button
(send button)
Charging contacts
(rear)
Speaker
SCAN
VOX
HI
LO
MENU
1.5V AAA
1.5V AAA
1.5V AAA
1.5V AAA
1.5V AAA
1.5V AAA
1

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Alecto FR-175 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Alecto FR-175 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,1 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Alecto FR-175

Alecto FR-175 Gebruiksaanwijzing - Nederlands - 2 pagina's

Alecto FR-175 Gebruiksaanwijzing - Deutsch - 2 pagina's

Alecto FR-175 Gebruiksaanwijzing - Français - 2 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info