429062
13
Verklein
Vergroot
Pagina terug
1/14
Pagina verder
61180019L1-5A Issue 1, May 2004 13
NOTE
The CO X.25 network administrator must
configure the X.25 switch for the Total Access
1500 19-Inch Chassis, accomplishing tasks
such as assignment of an LDN number for the
chassis.
Connect 10Base-T
The Total Access 1500 System can provide SNMP
management capability over an Ethernet. Access to the
network is via the RJ-45 10Base-T connector,
J33,
located on the upper right side of the backplane.
WARNING
The 10Base-T Ethernet interface MUST NOT
be metallically connected to interfaces which
connect to the Outside Plant (OSP) or its
wiring. This interface is designed for use in
intra-building interfaces only. The addition of
Primary Protectors is not sufficient protection
in order to connect these interfaces metallically
to OSP wiring.
To connect the Total Access 1500 19-Inch Chassis to
the Ethernet ring, simply plug the male RJ-45 modular
connector into the female RJ-45 port,
J33, on the Total
Access 1500 19-Inch Chassis backplane. When
planning the cable run to the Total Access 1500 19-Inch
Chassis, be sure to allow enough cable for routing the
cable to the right from the backplane connector to the
frame and for tie off in accordance with CO SOP.
There are two provisional items in the SCU: Telnet port
and TCP/IP port. Specify the Telnet port to access
menus over the Ethernet, and specify the TCP/IP port to
issue TL1 commands.
Connect to PairGain Test Controller (PGTC)
Use a straight through 50-pin amp cable to connect the
PairGain Test Controller to the PGTC interface (
P5) of
the Total Access 1500 19-Inch Chassis.
P5 accepts a
female connector.
3. MAINTENANCE
The Total Access 1500 19-Inch Chassis does not require
routine maintenance for normal operation.
ADTRAN does not recommend that repairs be
attempted in the field. Repair services may be obtained
by returning the defective unit to ADTRAN. Refer to
the Warranty and Customer Service section for further
information.
4. SPECIFICATIONS
Specifications for the Total Access 1500 19-Inch
Chassis are detailed in Table 2.
Table 2. Specifications
Power Requirements
Input DC Voltage: –42 VDC to –56 VDC
DC Voltage Nominal: –48 VDC
Maximum Current: (5-amp fused) on PSU
Environmental
Operating Temperature: –40°C to 65°C
Storage Temperature: –40°C to 85°C
Relative Humidity: Up to 95% noncondensing
Physical
Dimensions: 3.50 in. H × 19.00 in. W ×
10.75 in. D
Weight fully loaded: 20 lbs.
Weight empty: 10 lbs.
Part Number
Total Access 1500 19-Inch
Chassis:
1180019L1
13

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Adtran total access 1500 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Adtran total access 1500 in de taal/talen: Engels als bijlage per email.

De handleiding is 4,25 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info