Introduction
Control Prog is a programmable IR-transmitter, which replaces ordinary remote
controls for TV, VCR and stereo sets. Control Prog has in all 241 different
programming positions and can be controlled by the integral keyboard or by
external control switches such as single- or multifunction switches (as well as
joysticks). When external control switches are used, different scanning options
can be chosen. The different functions can be controlled from a computer but it
is also possible to control functions on a computer from Control Prog.
News and Improvements
Control Prog has been further improved compared to earlier versions of Gewa
Prog III, which means that there will be new features available such as:
New design on casing
Rubber protection for inputs
Increased number of levels (5)
New functions to control a computer
Improved battery warning
Improved labelling of the keyboard
Location for level indication has been moved
Relay output changed
General Information about Control Prog
To be able to use Control Prog there are certain things you should know:
For programming, press the programming button using a pen, for example, at
the same time as you choose a function key. Different function keys are
chosen depending on what you want to program.
If you press the wrong key or if there is a programming mistake you can
always press the programming button on Control Prog. It works as a reset
button.
It is important not to wait too long between the different steps when
programming. After a certain time Control Prog automatically leaves the
programming mode to save power.
If a key on the keyboard or a scanning switch is pressed for more than 20
seconds, Control Prog will stop transmitting to save power.
