524607
6
Verklein
Vergroot
Pagina terug
1/30
Pagina verder
7
4
53 6
1
2
E-Tech W : 664Y6500 • B
en
6
EN
FR
NL
ES
IT
DE
PL
RU
INTRODUCTION
US E R DATA
All user controls are situated on the front panel of the boiler, there are no user controls inside the boiler
casing.
The following instructions assume that the boiler has been commissioned, and that the system is filled
with water and has been fully vented.
SETTING UP
Before switching on any electrical supplies to the boiler ensure that the combined temperature and
pressure gauge reads at least 1 bar and the control thermostat is set to the desired temperature.
If an internal time clock is fitted ensure that this is switched on (see “Optional Internal Time Clock)
and if any other auxiliary controls are fitted e.g. programmer, room thermostats, cylinder thermostats
etc, consult appropriate manufacturers’ instructions to switch these on.
Switch on any local means of isolation to boiler.
Switch the boiler on using the ON/OFF switch (the neon light on the switch should now glow).
Turn on both power level switches - after a short period of time the boiler temperature should start
to rise, indicated by the combined temperature and pressure gauge. If the boiler fails to operate, the
overheat safety thermostat should be checked.
Access to the thermostat reset button is obtained by unscrewing (anti-clockwise) the domed button
cover on the front panel (a screwdriver is not required).The reset button can then be seen - press the
button, a click should be heard and the button is reset. If no click was heard the device is not at fault
and further investigation is required by a suitably qualified engineer.
The internal clock or external programmer can now be set to allow on/off periods as desired.
The ON/OFF switch and 2 power level switches should be left in the ON position during normal use.
The power level switches will automatically switch on and off during normal boiler
operation, depending on boiler temperature.
If the boiler is not in regular daily use during cold periods, it is recommended that it be fitted with a
frost sensing thermostat to override the timeclock and prevent the system from freezing.
As with most boilers and heating appliances the casing and pipework can get hot during normal
running so the boiler must not be covered and the surrounding area must be kept clear.
OPTIONAL INTERNAL TIME CLOCK
This operates on a 24-hour sequence. Around- the outside of the clock there are a number of white
tabs - these allow 15 minute switching times. To set a boiler cycle simply push outwards the number
of tabs required for your heating period.
Remember : Tab OUT = BOILER ON
Tab IN = BOILER OFF
The time of day is marked by an arrow on the inner part of the clock - set the outer time to coincide with
this arrow.
On the centre part of the clock there is a switch.
This has three positions :
Switch down - time clock off
Switch middle - time clock timed (normal position)
Switch up - time clock on constant.
PRESSURE IN THE HEATING SYSTEM
The CH pressure must be a minimum of 1 bar and must be checked by the end user on a regular basis.
If the pressure drops under 0.5 bar, the integrated water pressure switch blocks the appliance until the
pressure in the system returns to a level above 0.8 bar.
The installer fits the system with a separate fill valve underneath the appliance. Make sure that the
appliance is powered off when filling the system. To do this, turn the on/off switch.
For more information, please ask your installer when the system is delivered.
A safety valve is provided underneath the appliance. If the system pressure exceeds 3 bars, this valve
opens and drains the water from the system. In this case, please contact your installer.
LEGEND
1. ON/OFF switch
2. Power levels switch
3. Optional internal clock or controller
4. Combined temperature and pressure gauge
5. Boiler shutdown indicator light
6. Manual reset high limit thermostat
7. Control thermostat :
1 = 1C
2 = 30°C
3 = 45°C
4 = 60°C
5 = 80°C
6

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw ACV ETech W 28 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van ACV ETech W 28 in de taal/talen: Engels als bijlage per email.

De handleiding is 5,08 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van ACV ETech W 28

ACV ETech W 28 Gebruiksaanwijzing - Nederlands - 24 pagina's

ACV ETech W 28 Gebruiksaanwijzing - Deutsch - 30 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info