Waterproof Case Using Notice
Before sealing the waterproof case, keep the camera housing’s rubber seal clean, a single hair or
grain of sand can cause a leak. You can test by closing the case without inserting the camera.
Submerse the case completely in water for about a minute. Remove the case from the water, dry
off its exterior with a towel, then open the case. If the entire interior is dry, the case is safe for use
under water.
After every use in salt water you will need to rinse the outside of the housing with non-salt water
and dry. Not doing this can eventually cause corrosion of the hinge pin and salt buildup in the
seal, which can cause failure.
To clean the seal, rinse in fresh water and shake dry (drying with a cloth may cause lint to
compromise the seal). Re-install the seal into the grooves in the backdoor of the housing.
