691438
4
Verklein
Vergroot
Pagina terug
1/6
Pagina verder
Port side, forward view
Port side, downward view
Starboard side, forward view
Starboard side, downward view
Installing the Transducer on a Transom
Assembling the Transom-Mount Hardware
1
Attach the transducer mount bracket to the transducer
using the mounting screws and lock washers .
2
Attach the transducer mount bracket to the transom mount
bracket using the bolts , flat washers , and lock nuts
.
NOTE: The recommended torque applied to the screw is
15 lb-ft. (20 N-m).
NOTE: If the transducer causes excessive spray when
mounted to the transom, you can purchase a deflector to
install between the transducer and mount bracket. Go to
buy.garmin.com, or contact your Garmin dealer for
information about optional accessories.
Installing the Transom-Mount Hardware
NOTICE
If you are mounting the bracket on fiberglass with screws, it is
recommended to use a countersink bit to drill a clearance
counterbore through only the top gel-coat layer. This will help to
avoid cracking in the gel-coat layer when the screws are
tightened.
1
Place the transducer mount so the top of the transducer is
under the transom.
2
Using the transom mount as a template, mark the location of
the pilot holes.
3
Wrap a piece of tape around a 4 mm (
5
/
32
in.) bit at 19 mm
(
7
/
10
in.) from the point of the bit, to avoid drilling the pilot
holes too deep.
4
If you are installing the bracket on fiberglass, place a piece of
tape over the pilot-hole location to reduce cracking of the gel
coat.
5
Using the 4 mm (
5
/
32
in.) bit, drill the pilot holes approximately
19 mm (
3
/
4
in.) deep at the marked locations.
6
Apply marine sealant to the included 20 mm screws.
7
Using the three 20 mm screws , attach the transducer
mount to the transom.
8
If you must route the cable through the transom, choose a
pilot-hole location well above the waterline and mark it.
9
If you marked a pilot hole in step 8, use a 32 mm (1
1
/
4
in.)
hole saw to drill a pass-through hole completely through the
transom.
10
Route the transducer cable to the sonar module:
If you are routing the cable using a pass-through hole,
push it through the hole you drilled in step 9.
If you are not routing the cable using a pass-through hole,
route the cable up and over the top of the transom .
You should avoid routing the cable close to electrical wires or
other sources of electrical interference.
Transom Mount Orientation
If necessary, to reduce spray you can install an optional splash
guard, available at buy.garmin.com or from your Garmin dealer.
Mounting the Sonar Module
Mounting the Panoptix LiveScope GLS 10 Device
NOTICE
If you are mounting the device in fiberglass, when drilling the
pilot holes, it is recommended to use a countersink bit to drill a
clearance counterbore through only the top gel-coat layer. This
will help to avoid cracking in the gel-coat layer when the screws
are tightened.
NOTE: Stainless-steel screws may bind when screwed into
fiberglass and overtightened. It is recommended to apply an
anti-seize lubricant to the screws before installing them.
NOTE: Screws are included with the device, but they may not
be suitable for the mounting surface.
Before you mount the device, you must select a mounting
location and determine what screws and other mounting
hardware are needed for the surface.
1
Place the device in the mounting location and mark the
location of the pilot holes.
2
Drill a pilot hole for one corner of the device.
3
Loosely fasten the device to the mounting surface with one
corner and examine the other three pilot-hole marks.
4
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Garmin Panoptix Livescope bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Garmin Panoptix Livescope in de taal/talen: Engels als bijlage per email.

De handleiding is 2,32 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Garmin Panoptix Livescope

Garmin Panoptix Livescope Installatiehandleiding - Nederlands - 6 pagina's

Garmin Panoptix Livescope Installatiehandleiding - Deutsch - 6 pagina's

Garmin Panoptix Livescope Installatiehandleiding - Français - 6 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info