Handleiding Casio 5325 (pagina 3 van 9) (Engels)

624831

Verklein

Vergroot

Pagina terug

1/9

Pagina verder

Operation Guide 5325

E-18

 Signal reception may be difﬁ cult or even impossible under the conditions described below.

Inside or among

buildings

Inside a vehicle Near household

appliances,

ofﬁ ce

equipment, or a

mobile phone

Near a

construction

site, airport, or

other sources of

electrical noise

Near

high-tension

power lines

Among or behind

mountains

3. What you should do next depends on whether you are using Auto Receive or Manual Receive.

 Auto Receive: Leave the watch over night in the location you selected in step 2. See “Auto Receive”

on page E-18 for details.

 Manual Receive: Perform the operation under “To perform manual receive” on page E-19.

Auto Receive

 With Auto Receive, the watch performs the receive operation each day automatically up to six times (up

to ﬁ ve times for the Chinese calibration signal) between the hours of midnight and 5 a.m. (according

to the Timekeeping Mode time). When any receive operation is successful, none of the other receive

operations for that day are performed.

 When a calibration time is reached, the watch will perform the receive operation only if it is in the

Timekeeping Mode. The receive operation is not performed if a calibration time is reached while you

are conﬁ guring settings.

E-17

 Signal reception may not be possible at the distances noted below during certain times of the year or

day. Radio interference may also cause problems with reception.

− Mainﬂ ingen (Germany) or Anthorn (England) transmitters: 500 kilometers (310 miles)

− Fort Collins (United States) transmitter: 600 miles (1,000 kilometers)

− Fukushima or Fukuoka/Saga (Japan) transmitters: 500 kilometers (310 miles)

− Shangqiu (China) transmitter: 500 kilometers (310 miles)

 As of December 2012, China does not use Daylight Saving Time (DST). If China does go to the

Daylight Saving Time system in the future, some functions of this watch may no longer operate

correctly.

 Using this watch in a country covered by a time calibration signal that is different from the countries it

supports may result in incorrect time indication due to local application of daylight saving time (summer

time), etc.

To get ready for a receive operation

1. Conﬁ rm that the watch is in the Timekeeping Mode. If it isn’t, hold down C for at least two seconds to

enter the Timekeeping Mode.

2. Place the watch in a location where signal reception is good.

12 o’clock

 Position the watch as shown in the nearby illustration,

with 12 o’clock pointed towards a window. Make sure

there are no metal objects nearby.

 Signal reception normally is better at night.

 The receive operation takes from two to 10 minutes, but

in some cases it can take as long as 20 minutes. Take

care that you do not perform any button operation or

move the watch during this time.

E-16

Approximate Reception Ranges

Japanese Signals Chinese Signal

UK and German Signals North American Signal

Anthorn

500 kilometers

1,500 kilometers

Mainﬂ ingen

The Anthorn signal is receivable

within this area.

2,000 miles

(3,000 kilometers)

600 miles

(1,000 kilometers)

Fort Collins

Fukushima

500 kilometers

1,000 kilometers

Fukuoka/Saga

1,500 kilometers

Changchun500 kilometers

Beijing

Shangqiu

Shanghai

Chengdu

Hong Kong

E-19

To perform manual receive

1. In the Timekeeping Mode (page E-24), keep B depressed (for about two seconds) as the x

Second Hand

goes through the following sequence.

 Moves to H (High), M (Mid), or L (Low) to indicate the power level and then moves to R (READY).

2. The x

Second Hand indicates the operations the watch is currently performing.

When the x Second Hand is pointed here:

It means this:

R (READY)

Watch is setting up for reception.

W (WORK) Reception is in progress.

 If signal reception is unstable, the x Second Hand may move between

W (WORK) and R (READY).

 When the receive operation is successful, the watch adjusts the time

setting accordingly, and then resumes regular timekeeping. It does not

adjust the setting if the operation failed.

 Signal reception is not performed when the power level is L (Low).

Note

 To interrupt a receive operation and return to the Timekeeping Mode, press any button.



E-20

To check the result of the latest receive operation

In the Timekeeping Mode, press B. The x

Second Hand will move to

H (High), M (Mid), or L (Low) to indicate the power level, and then it will

indicate the latest time calibration signal receive operation result.

 The x

Second Hand will move to YES (Y) if the latest receive operation

was successful, or NO (N) if it was not. After about 10 seconds, regular

timekeeping will resume.

 Press B to return to regular timekeeping. The watch will also return

to regular timekeeping if you do not perform any operation for about

10 seconds.

Note

 The x

Second Hand will indicate NO (N) if you have adjusted the time or day

setting manually since the latest receive operation.

To turn auto receive on and off

1. In the Timekeeping Mode, press B. The x

Second Hand will move to

H (High), M (Mid), or L (Low) to indicate the power level, and then it will

indicate the latest time calibration signal receive operation result.

2. Pull out the crown.

The x

Second Hand will perform one full revolution and then stop at the

current on/off setting.

3. Rotate the crown to move the x

Second Hand to the setting you want.

 To turn on auto receive, select YES (Y).

 To turn off auto receive, select NO (N).



YES (Y)

NO (N)

E-21

4. Push the crown back in to return to the Timekeeping Mode.

Radio-controlled Atomic Timekeeping Precautions

 Strong electrostatic charge can result in the wrong time setting.

 Even if a receive operation is successful, certain conditions can cause the time setting to be off by up

to one second.

 The watch is designed to update its day setting automatically for the period from January 1, 2000

to December 31, 2099. Updating of the day setting by signal reception will no longer be performed

starting from January 1, 2100.

 If you are in an area where signal reception is not possible, the watch keeps time with the precision

noted in “Speciﬁ cations” (page E-64).

 The receive operation is disabled under any of the following conditions.

− While power is at Level 2 or lower (page E-12)

− While the watch is in the power recovery mode (page E-13)

− While the watch is in the function sleep state (power saving, page E-14)

− While the watch is not in the Timekeeping Mode

− While a direction reading or Countdown Timer operation is in progress (even if the watch is in the

Timekeeping Mode)

 A receive operation is cancelled if an alarm sounds while it is being performed.

E-22

Mode Reference Guide

Your watch has ﬁ ve “modes”. The mode you should select depends on what you want to do.

To do this: Enter this mode: See:

 Conﬁ gure Home City and DST (daylight saving time) settings

 Perform a time calibration signal receive operation or view the last

receive result

 Change the Auto Receive on/off setting

 Conﬁ gure time and day settings manually

 Check the current power level

 Determine magnetic north

Timekeeping Mode

E-24

E-32

 View the current time in one of 29 cities around the globe

 Conﬁ gure World Time City and summer time settings

 Swap the Home City and World Time City

World Time Mode

E-42

E-43

E-45

Measure elapsed time and lap times, and recall lap times Stopwatch Mode E-46

Use the countdown timer Countdown Timer Mode E-49

 Set an alarm time

 Turn the alarm ON or OFF

Alarm Mode

E-52

E-54

E-23

Selecting a Mode

With this watch, everything starts from the Timekeeping Mode.

To determine the watch’s current mode

Check what the b

Lower Dial Hand is indicating as shown under “To select a

mode” (page E-23).

To return to the Timekeeping Mode from any other mode

Hold down C for at least two seconds.

To select a mode

Each press of C will cycle between modes. The currently selected mode is indicated by the b

Lower

Dial Hand.

Timekeeping Mode World Time Mode

Stopwatch ModeCountdown Timer Mode

Alarm Mode



Casio 5325 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Andere handleiding(en) van Casio 5325

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info