30198
7
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
INSTALLATION
When installing the radio system to the model, please follow the detailed instructions for the
model kit.
A.Normal Installation (non BEC)
If you are using the regular mechanical speed control that usually comes with the model
kit, you will need both servos, and the battery harness that comes with the radio set.
Incidentally this is the installation method for the engine equipped model as well.
B.ESC installation (Electronic Speed Control)
You may wish to use an ESC in place of the mechanical speed control and throttle servo.
This will allow more precise control as well as less power consumption. Please note that
most ESC’s are already equipped with BEC so you can simply plug into channel two of
the receiver.
Installation diagram fig 7
HELPFUL HINT
A.BATTERY
Always take extra care that all the batteries in the radio set are fully charged (NiCad) or
fresh (Dry) when operating you radio. Otherwise the receiver range will substantially be
reduced and lose control thereby damaging your model and or people. When you re-
charge your transmitter NiCads with a charger jack, be careful of its polarity. The inner
contact should be positive (+), the outer negative (-). For your convenience, we recom-
mend our genuine overnight charger. CG-22(220V0 or CG-25(110V).
B.ANTENNA
Both the transmitter and the receiver antenna must be fully extended when in use. Be
careful that you do not cut off the excess receiver antenna wire or bundle it. This will
severely cut down on the operating range.
C.XTAL CHANGE
When changing the frequency to another channel, make sure that you match the trans-
mitter to the receiver channel. Also you must make sure that they are replaced with only
genuine Hitec single conversion FM xtals as not all xtal makes are compatible with each
other. Also remember that you can change frequencies only within the same frequency
band, which means you cannot change to 72MHz from 75MHz. (Also in the US, you
may not be allowed to change the transmitter xtal).
NORMAL INSTALLATION
E.S.C. INSTALLATION
7.2V ~ 8.4V
7

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Hitec RANGER_IIIFM bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Hitec RANGER_IIIFM in de taal/talen: Engels als bijlage per email.

De handleiding is 0,36 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info