5
Important
For additional protection, the installation of a residual current device (RCD) having a rated resi-
dual operating current not exceeding 30mA is advisable in the electrical circuit supplying the ba-
throom. Ask your installer for advice.
USE
COMPONENTS
1. Hair clippers
2. Set of blades
3. Switch
4. Charge light: red while charging
5. Mains adapter socket
6. Base
The appliance can operate either using mains power or in cordless mode, as it has a re-
chargeable battery.
MAINS POWER SUPPLY
Connect the transformer the (fig.1 - reference 9) by inserting the plug into the appliance socket (fig.1 - ref.5).
Plug the transformer into the mains.
Warning: if the appliance does not work with mains power when the battery charge has run down completely,
switch it off, recharge the battery for about five minutes and then switch back on again, running on mains power.
RECHARGING THE BATTERY
• Before using the appliance for the first time, charge the battery for 24 hours. For subsequent charges, allow
the appliance to charge for at least 8 hours.
• Switch the appliance off using the switch (fig.1 - ref.3). The battery can only be charged with the appliance
switched off.
• Connect the transformer (fig.1 - ref.9) by inserting the plug into the appliance socket (fig.1 - ref.5). Or connect
the transformer to the base (fig.1 - ref.6) by inserting the plug into the base plug (fig.1 - ref.7), then sit the
appliance on the base.
• Plug the transformer into the mains.
• During charging the led (fig.1 - ref.4) lights up to indicate charging in progress.
• Only recharge the battery when you note a clear reduction in appliance power.
• When the battery is fully charged, the appliance can be used for 60 minutes without connection to the mains.
REMOVING AND ADJUSTING THE COMB ATTACHMENT
• To adjust the cutting length, slide the comb as illustrated in figure 2: move it in the direction of arrow A to
increase the cutting length, or in the direction of arrow B to decrease the cutting length.
• To remove the comb, move it in the direction of arrow A until it slides off the appliance completely
CHANGING BLADES
• Switch the appliance off.
• To remove a blade, push to release from the seat as shown in (fig.3).
• To refit a blade, follow the instructions in (fig.4): first insert the rear section in the seat (A), then push the front
to secure in place (B).
CARE AND MAINTENANCE
The cleaning and maintenance procedure must be carried out after every use.
• All maintenance or blade change operations must be carried out with the appliance switched OFF and removed
from the mains adapter.
• Never immerse the appliance in water!
• After every use, remove the guide comb then use the small brush to eliminate any hair from the cutting head
and its seat.
7.
Mains adapter socket on base
8.
Adjustable comb attachment- 3, 6, 9 mm
9.
Transformer
10.
Cleaning brush
11.
Lubricant
