n Plug the telephone line cord to the connector (1) of the machine and
connect the other end to the wall telephone socket.
n Plug the power supply unit to the connector (2) and the power cord into an
A.C. outlet .
n Open the front and the back cover (3, 4).
n Place the ink ribbon kit above its housing under the back cover (5).
n Put it in its housing without removing the adhesive tape.
n Remove the adhesive tape .
n Place the small roll in its housing (6).
n Installing the ribbon gauge.
n Remove gauge housing cover (7):
. slide the cover towards the back,
. remove the gauge mini-card (9) from the support card (8).
n Insert the gauge (9) in the slot (10) of its housing with the chip facing you
and the bevelled corner positioned on top right.
n Replace the gauge housing cover (9).
n Close the back cover (4), then the front cover (3).
CHAP7 2/09/98, 12:4012