566741
1
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
DA SEGNO SET – Cordless doorbel set UK - 1
PAC-324
The cordless doorbell consists of 2 separate
components:
1. Push-button unit (transmitter)
2. Bell unit (receiver)
These items are completely independent of each
other and require no wiring.
When the push-button is pressed in, a signal is sent
to the bell, whereupon the bell is activated. Since it
has a range of up to 100 metres (in open spaces)
you can use the bell virtually anywhere in the house,
workshop, office, set it up in the garden or just carry
it with you.
Battery installation
Push-button unit
1. The push-button unit works using 1 x 3v
(CR2032) lithium battery (included).
2. The lithium battery is already installed.
Open the push-button and remove the
insulator strip.
3. Snap the rear side back into position, and
the push-button is ready for use.
To replace the battery:
1. Open up the push-button unit.
2. Remove the metal plate using a
screwdriver.
3. Place a 3v battery (CR2032) in the battery
compartment, making sure the positive
terminal (+) is uppermost.
Bell unit
1. Slide the rear cover open.
2. Place 2 C alkaline batteries into the battery
compartment.
3. The bell unit will produce a two-tone signal,
indicating that it is ready to read a digital
code (see channel selection).
4. Slide the cover firmly back into place; the
bell is now ready for use.
Installation
Push-button unit
Use the two small holes on
the rear of the push-button to
mark the position for
securing in place. Drill small
holes and mount the push-
button in position with
screws (self-tapping 3 x
16mm, included) or use the
double-sided adhesive tape
(included).
Important: If you secure the
push-button onto a metal
upper surface or PVC type of door (with metal), its
maximum range of transmission will be greatly
reduced.
Bell unit
This bell can be used as a portable device - or fixed
into position. On the reverse side, there are two
suspension slots, with which the bell can be hung
up using a screw, and can easily be taken down
again.
Choice of bell tone
The bell-tone selector button is inside the push-
button unit, below letter “S”. Press the button once
to hear the bell tone already set. Press again to
hear and select the next tune.
1) Westminster 2) Ding Dong
3) Ding-Dong-Ding 4) Tubular – 1
5) Orchestra 6) Tubular – 2
7) Trumpet 8) Dog Barking
Optionally: It is possible to instal an extra push-
button by your back door. By applying the procedure
given above, each push-button can produce a
different tune.
Channel selection
The unit is supplied with a pre-set radio frequency. If
by chance the bell should sound for no apparent
reason, it's possible that another device nearby is
using the same frequency. To get round this
problem, you can change the frequency of the push-
button and bell.
1. remove the cover behind the push-button.
2. To program or change: remove the
batteries from the bell unit for at least 30
seconds to prime the memory.
3. place the batteries back into position
within. Press the push-button after the two-
tone signal sound (with a second press of
the button if need be) to confirm the new
code. Do this within 1 minute. Don’t use
any other cordless products for the next 5
minutes.
4. Test for correct operation.
LED function
When the push-button is pressed, the gong will
sound. At the same time the blue LEDs will also
light up - ideal for the hard of hearing or when using
in a noisy environment. The light will show for
approx. 10 sec in order to attract the attention. If use
of LEDs is not required, they can be switched off by
means of the on/off button at the battery
compartment.
Mode function
1 x push: light and sound
2 x push: light
3 x push: sound
Volume selection
There is a volume-selector buttonat the pack of the
bell unit.
Trouble-shooting and tips
Problem:
Bell rings, but LEDs fail to light up
Possible cause:
The bell is out-of-range (max. 100m in open
spaces)
Push-button and bell are not set to the same
frequency
Possible solution:
Move the bell within range
Reprogram the channel (see channel selection)
Problem:
1

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Profile PAC-324 Da Segno bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Profile PAC-324 Da Segno in de taal/talen: Engels als bijlage per email.

De handleiding is 0,05 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Profile PAC-324 Da Segno

Profile PAC-324 Da Segno Gebruiksaanwijzing - Nederlands - 2 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info