648804
8
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
S
S
H
H
O
O
R
R
T
T
A
A
G
G
E
E
O
O
F
F
W
W
A
A
T
T
E
E
R
R
I
I
N
N
T
T
H
H
E
E
B
B
O
O
I
I
L
L
E
E
R
R
The water in the boiler may run out if the
recharging system is not working properly.
This type of malfunctioning is signalled by the
lamp (D) starting to flash and by a buzzer. If
the problem persists contact the service cen-
tre.
T
T
R
R
A
A
N
N
S
S
P
P
O
O
R
R
T
T
This device can be moved easily by means of
the transport grip (I) on the rear of the device
or using the two side handles. If required, the
transport grip can be removed by unscrewing
the two wing screws on the rear of the handle.
WARNING: Never drag the device by the
nozzle. Move it only by means of the grip (I)
or the two side handles.
S
S
T
T
O
O
R
R
I
I
N
N
G
G
T
T
H
H
E
E
D
D
E
E
V
V
I
I
C
C
E
E
.
.
When you have finished using the device, put
it away in a clean and dry place after discon-
necting it from the power mains. Keep it away
from sources of heat and protect from the
weather. Do not expose the device to extreme
temperatures. Disconnect the tank (Q) from
the nozzle before putting it away or when the
device will not be used for some time.
M
M
A
A
I
I
N
N
T
T
E
E
N
N
A
A
N
N
C
C
E
E
Before carrying out any maintenance on
the device, always unplug it from the power
mains and allow it to cool down before pro-
ceeding.
If the monotube is torn, it must be replaced by
an authorised service centre.
Cleaning of the delivery nozzle
Clean the delivery nozzle every 10-15 hours of
use. Clean the delivery nozzle using the brush
(T) included in the supply, sliding it inside the
tube so as to remove any residues of scaling in
it (Fig.8).
Lubrication of the coupling
Whenever it is difficult to fit the connector (Q)
and in any case when the device has not
been used for some time, lubricate the cou-
pling on the bottom of the delivery device
(fig.9) with a synthetic lubricant. It you find it
difficult to insert the connector even after lu-
bricating, contact an authorized service cen-
ter.
Tips
In the event of external factors such as, for ex-
ample, a sudden change in voltage due to an
upset in the network (failure, lightning, etc.),
the device may be affected by electrical inter-
ference and be subject to temporary malfunc-
tioning.
To reset the device, switch it off and discon-
nect it from the mains for a few minutes. After
this procedure, start it again normally. If it still
does not work correctly, ask for a check up at
an authorised service centre.
Having the device checked after a problem of
this kind is recommended.
External cleaning
For cleaning the outside of the device we rec-
ommend using a damp cloth. Do not use sol-
vents or detergents as these could damage
the surfaces. Pay special attention to the
cleanliness of the outside of the device when
moving from one room to another, cleaning the
wheels too.
WARNING: For all other maintenance pro-
cedures and whenever necessary, contact
an authorised service centre. Do not at-
tempt under any circumstances to disas-
semble the device or to open it.
SANI SYSTEM POLTI
39
E
E
N
N
G
G
L
L
I
I
S
S
H
H
SANI SYSTEM 02 M0S08288 1O05:A5 06/06/2008 17.05 Pagina 39
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Polti Sani System Polti bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Polti Sani System Polti in de taal/talen: Engels als bijlage per email.

De handleiding is 0,95 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info