The GS-130 detects all mixtures of air and combustible gas (Natural Gas, Me-
thane, Propane, Butane, GPL, etc). The detector detects two levels of gas con-
centration - different output reactions.
The main GS-130 features are: high reliability and sensitivity, compact size,
230V (110V optional) power supply and long stability & lifetime.
Installation
A professional installer should install the
detector. (recommended in compliance
with EN 50244).
Fix the detector on the
wall. For gases lighter than
air (natural gas, city gas etc.)
install it close to the ceiling
(max. 15 cm under it) or
directly on the ceiling and on
the place expected to have
gas leakage. For gases
heavier than air (propane,
butane, etc.) install it close to
the floor or on the lowest
place of the room. The
detector should not be
located close to any obsta-
cles preventing natural air
circulation.
Memory
The memory function is disabled by factory default (when the concentration of
the gas drops down to normal, the GS-130 will stop the alarm signal).
Close the MEM jumperto select the memory function. Then the alarm indica-
tion, if triggered, will not stop unless the GS-130 power supply is terminated for a
while.
Power supply
Connect the power cord to the terminals marked 230V AC (or 110VAC). The
power inlet should be fused with an external fuse (max. 10A).
Outputrelay function
There is a dry relay contact available on the GS-130 output terminals:
•C - common contact
•NO- normally open contact
•NC- normally closed contact
This relay output can be used for an automatic gas-valve closer, alarm system
triggering or for other warning systems.
When the automatic gas-blocking function is used, the application of this shall
be according to national regulations and EN1775.
If the REL jumper is open, the relay will be triggered after the 1st level of gas
concentration is detected. If the REL jumper is closed, the relay will be triggered
after the 2nd level of gas concentration is detected.
green LED
red LED
NO230V
JABLOTRON
GS-130
REL
AUX
MEM
CACNC
buzzersensor
Fig. 2
red LED
Function
After switching the power on, the green LED willflash for 60 sec. (the detector
warms up). When the green indicator lights permanently the detector is ready.
If the gas concentration reaches the 1st level, short beeps will sound and red
LED I will go off.
If the gas concentration reaches the 2nd level,long beeps will sound and red
LED II will go off.
The output relay reacts depending on the REL jumper setting.
Warning -in the case of a gas alarm stay calm and act as follows: -do not
operate any switches
-do not use any kind of phone in the location of the gas leakage
-open any windows
-stop the gas leakage if possible or leave the place and call the gas
supply company
Warning – leaking gas can be smelled before the detector detects an
alarm-level concentration of gas. In this case, the cause of the gas
leak should be eliminated immediately.
Maintenance and testing
Keep the detector clean, it is important that its grids should not be blocked with
dust.
Use a gas cigarette lighter without the flame lit, to test the gas detector’s reac-
tion. Thedetector will react within 15 seconds.
Professional recalibration of the detector should be done at least once a
year. Contact your distributor for more details.
LED indicators
Green
•OFF
•Flashes
•ON
The detector is off
Warming up
Ready for gas alarms
Red I.
•ON
1
st
level of the gas concentration
Red II.
•ON
2
nd
level of the gas concentration
Red II.
Green
•Alternating
flashes
Error in the sensor
Specification:
Sensitivity (gas concentration):
Methane
Propane
Level 1
10
±
3% LEL (0.50% vol.conc.)
18
±
3% LEL(0.30% vol. conc.)
Level 2
18
±
3% LEL (0.80% vol. conc.)
30
±
3% LEL (0.50% vol. conc.)
Iso-butane
Level 1
23
±
3% LEL(0.30% vol. conc.)
Level 2
40
±
3% LEL (0.50% vol. conc.)
LEL = Lower Explosive Limit (100 %) according to EN 60079-20-1: for
methane 4,4 % vol. conc., for prophane 1,7 % vol. conc., for iso-buthane
1,3 % vol. conc., calibrated by iso-butane
Power supply230V(-15% to+10%) / 50Hz, 2 W, protection class II
Detection methodhot platinum filament
Buzzer sound level94dB/0.3m
Relay outputoptional for 1st or 2nd level, max. 230V AC/5A
Alarm memoryselectable
Response time20 s
Warm up timeapproximately 90 s
Working environment indoor use, -10 to +40°C, IP30
Working humiditymax 80 %
designed to operate at normal atmospheric pressure86 to 106kPa
Complies with EN 50194-1, EN 60079-29-1, EN 50130-4,
EN 55022, EN 60950-1
For non-explosive areas. Zone 2 according to EN 60079-10.
Certified by VVUÚ corp., certificated body No. 3076, by FTZÚ corp., certifi-
cated body No. 3051
Complies with the essential requirements of: 2006/95/ECLow
VoltageDirective- Health and safety protection, 2004/108/EC
EMC Directiveconcerningelectromagnetic compatibility and
2011/65/EU RoHSwhen used for its intended purpose.The
original of the conformity assessment can be found at
www.jablotron.com, Technical Support section.
Note: Although this product does not contain any harmful materi-
als we suggest you return the product to the dealer or directly to
the producer after use.
ready
green
red
1st level
2nd level
Fig. 1
OK
I.
II.
red
Gas Leak Detector GS-130 2/2 MEF51016
Hulp nodig? Stel uw vraag in het forum
Misbruik melden
Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.
Product:
Spelregels forum
Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:
lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;
Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.
Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.
Abonneren
Abonneer u voor het ontvangen van emails voor uw Jablotron GS-130 bij:
nieuwe vragen en antwoorden
nieuwe handleidingen
U ontvangt een email met instructies om u voor één of beide opties in te schrijven.
Ontvang uw handleiding per email
Vul uw emailadres in en ontvang de handleiding van Jablotron GS-130 in de taal/talen: Engels als bijlage per email.
De handleiding is 0,34 mb groot.
U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.
Uw handleiding is per email verstuurd. Controleer uw email
Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.
Er is een email naar u verstuurd om uw inschrijving definitief te maken.
Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken
U heeft geen emailadres opgegeven
Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.
Uw vraag is op deze pagina toegevoegd
Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.