109371
5
Verklein
Vergroot
Pagina terug
1/7
Pagina verder
9
as other appliances that run on energy
sources other than electricity, provision
must be made for an adequate supply of
air.
No food must be cooked flambé
underneath the hood. The use of an
unprotected flame is dangerous for the
filters and could cause fires.
Therefore, never use an open flame under
the hood. When frying foods, never leave
the pan unattended because the cooking
oil could flare up.
Please comply with the provisions set
forth by current regulations regarding the
ventilation of hoods.
The manufacturers will not be held liable
for damage to the hood or fires due to the
failure to observe the above instructions.
Electric connection
Before completing any connections, make
sure the house voltage corresponds with
the voltage indicated on the data plate affixed
to the inside of the hood.
It is advisable to call a qualified technician to
make the electrical connection.
Hood Fitted with Plug
Insert the plug into a socket which complies
with current regulations.
If you intend to connect the hood directly to
the mains, remove the plug and fit an
approved bipolar switch with a minimum
contact opening of no less than 3mm.
If the plug is not accessible once it has been
inserted in the socket, it will, however, be
necessary to fit an approved bipolar switch
with a minimum contact opening of no less
than 3mm.
Appliance without Plug
Fit an approved plug or an approved bipolar
switch with a minimum contact opening of
3mm.
The manufacturers will not be held liable for
any problems caused by the user’s failure to
observer the above instructions.
Mounting the Hood
The diameter of the ventilation duct must be
the same as the that of the flange mounted
on the ventilation hole on the hood. The
horizontal sections of the ducting must be
installed at a slight angle (about 10%) to
facilitate venting the vapours and fumes
outdoors.
To mount the hood proceed as follows:
a. Drill holes in the bottom of the cabinet so
that they correspond with the holes (F) in
the hood used to fasten it to the cabinet.
Use the drilling template if it has been
provided (the edge with the arrow should
correspond with the back edge of the
cabinet - Fig. 7).
b. Drill a hole on the back and in the top of
the cabinet for the ventilation duct (a
good rule of thumb is to make the diameter
of the hole 15 mm larger than that of the
duct used).
c. Insert the C screws supplied with the
hood into the F holes and tighten the
hood to the cabinet (Fig. 7).
Assembly using side brackets
(if supplied)
The hood can also be mounted by means
of two brackets supplied with the hood.
To fix the hood in this way (Fig. 8-9), proceed
as follows:
a. Drill two holes Ø 2 mm on the two sides
of the cupboard from the inside using the
template Q supplied.
b. Fix the two brackets T to the upper side
of the hood using screws V 4,2 x 35 (the
position of the brackets can be adjusted
in width according to the thickness of the
cupboard panels).
c. Fix the hood, through the brackets already
mounted, on the inside of the cupboard
using screws Z 3,5 x 13 (two each side).
Adjusting the Pull-Out Drawer
The hood can be installed beneath cabinets
with varying depths. Adjustments for opening
and closing the drawer can be made based
on your specific needs.
To adjust the drawer, remove the ventilation
grates by loosening the M screws and
adjusting the P brackets. Then retighten the
M screws (Fig. 10).
GB
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Smeg KSET 65 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Smeg KSET 65 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,15 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Smeg KSET 65

Smeg KSET 65 Gebruiksaanwijzing - Nederlands - 8 pagina's

Smeg KSET 65 Gebruiksaanwijzing - Deutsch - 8 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info