441342
11
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
Manual SA 235
pag. 10
Whether the 1 point or 3 point adjustment procedure is in operation can be
determined as follows:
1. switch the scale off if he is on
2. press together both the keys + and keep them pressed
3. switch the scale on with key and listen to the "beep"
4.1 if 1 x a "beep" sounds during switching on, the 1 point
procedure is in operation (H2 in the menu)
4.2 if 1.5 x a "beep" sounds during switching on, the 1 point
procedure is in operation (H1 in the menu, the 2
nd
beep is very short . .)
The selection of the adjustment procedure will be switched over any time
again this procedure is executed as per point 1 . . 3 (see above).
The adjustment mode may be entered as follows:
1. switch the scale off if he is on, switch off the count and check weighing.
2. press key and keep it pressed.
3. switch the scale on with key > 1 sec.
4. wait until de reading is zero, then release key
5. press together all the 3 keys + + until Sp appears.
6. now is shown the actual weighing capacity, it can be changed with key,
however regard the capacity of the loadcell ! Never select a higher
capacity, it will cause destruction of the loadcell !
7. confirm with key , het display toont: LS - - - -
8. start the zero point adjustment, using key again.
9. now the zero adjustment is executed, the most right display figure
runs down from 5 to 0 .
10. continue with the 1 point or the 3 points adjustment procedure, depending
on the display showing: H2 or: H1 .
1. the display shows H2 = 1 point adjustment procedure is selected.
2. now place accurate weights of 2/3 of the maximum weighing range
on the weigh platform. (e.g. for a 3 kg scale: place 2 kg)
3. confirm with key , automatically followed by:
4. the weight adjustment will be executed, the most right display figure
runs down from 5 to 0 .
5. the scale turns off automatically, remove the weight.
6. the scales switches itself on again in the weighing mode.
WEEGTECHNIEK HOLLAND B.V. Website www.satex.nl Tel +31 36 522 20 30
Patroonsweg 23 Email info@satex.nl Fax +31 36 522 20 60
3892 DA ZEEWOLDE The Netherlands
ADJUSTING THE SCALE
Select: 1 point or 3 point adjustment
Entering the calibration / adjustment Mode (in the lb mode to be executed in kg)
1 point adjustment: H2
returns
from 5 to 0
returns
from 5 to 0
11

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Satex SA 235 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Satex SA 235 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,87 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Satex SA 235

Satex SA 235 Gebruiksaanwijzing - Nederlands - 12 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info